Questions & Answers for: Pontiac Bonneville fuel level

Question about 1997 Bonneville

1 Answer

...fuel level, some times that float arm gets jammed and wont show your actual fuel level,to fix this with your gas tank at least half full use a rubber mallet or any other object that wont damage the ...

Ad

...fuel level reading to the gas gauge via wire transfer. this sending unit is located and attached to the fuel pump assembly inside the gas tank. replacing this device will fix this issue as well. ...

Ad

Question about 2001 Bonneville

1 Answer

...on two occasions has stalled out, as soon as the gas levels out it will restart. can be annoying. is there a way to correct this?? You need to replace the fuel level sender...located in the fuel

...fuel level and batty volt gauges are affected too. Its a very common problem with GM vehicles. YOUR FUEL GAUGE IS BROKE OR THE FUEL LEVEL SENDER UNIT IN GAS TANK FAULTY OR STUCK.BUT IF YOU NEED TO ...

10 MINUTES LATER, GUAGE DOES NOT SETTLE TO PROPER LEVEL...GOES ALL THE WAY UP TO FULL its the fuel sending unit in your gas tank mines going up to.while your tanks down you should do the fuel pump too

...fuel level sender or a bad fuel gauge, a bad gauge would mean replacing the cluster,I would run gas low and drop the tank, remove the fuel assm, the sender is the part that holds the pump, i will ...

Question about 1996 Bonneville SE CA Value

1 Answer

...fuel tank level sensor for the dash fuel gauge? If you go to Rock Auto.Com-- you will see that the sending unit is about $50.00 The mechanic is really screwing you over for sure Drop the fuel tank ...

Question about 1996 Bonneville SE CA Value

1 Answer

...may be that you didn't run out of fuel but the fuel pump quit-check the fuse-you more than likely need a new fuel pump-the fuel pump and the fuel level sensor are one unit in the fuel tank-cheers ...

Question about 1999 Bonneville

1 Answer

1999 pontiac stall stall Check fuel level and fuel pressure.

...fuel level as determined by the PCM. The IPC receives a class 2 message from the PCM indicating the fuel level percent. The fuel gage defaults to empty if: • The PCM detects a malfunction in the fuel ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Manuals & User Guides

Loading...