Questions & Answers for: Chrysler fuel level

DOING IT WHILE THE CAR IS RUNNING. Abraded insulation on the fuel gauge sender wire (intermittent short to ground). Bad fuel level sensor. Corroded or broken connector in the fuel gauge sender circuit

Ad

...and the "gas light" is coming on even though there is 1/2 tank of gas. Could this be indicater the fuel pump is going bad? no, maybe the fuel level switch, fuel gauge, or the wiring ...

Ad

Question about 1999 Town & Country

1 Answer

...fuel level when the ignition key is turned off and then again when the ignition key is turn back on. This is done to monitor for fuel level increase. If a fuel level increase is detected and the EVAP ...

...Fuel Gague reads 3/4 yet runs out of gas and dies. Upon refueling, (1 gallon) it will start and run fine though quits again at 3/4 tank. This problem began happening at 1/4 tank last year slowly ...

Question about 1999 Town & Country

1 Answer

...fuel level Most likely its the sending unit in the fuel tank. Your sending unit is probably one unit with the fuel pump. Very rarely is it the gauge in the dash. Your local friendly mechanic can take ...

Question about 1999 Town & Country

1 Answer

...level vary from fuel sloshing around. If the reading fluctuates, may be bad connection to wiring harness. If not, its faulty. Take pump/sender out and get new one on warranty from parts ...

Question about 2005 Pacifica

1 Answer

...fuel level sensor were the lower part of the sensor that indicates how much fuel there is below half a tank.the only way is to remove the unit from the tank and inspect for damage,it may have to be ...

Question about 2002 300M

1 Answer

...Fuel Level Sensor Circuit Low Voltage. Possible causes - Faulty fuel level sensor - Fuel level sensor harness is open or shorted - Fuel level sensor circuit poor electrical connection Low fuel level ...

...fuel light keep blinking? Blinks even when it's full of gas. Has new fuel pump, ecm, , throttle body sensor,airflow sensor , new fuel injectors maybe the fuel level sensor or it's wiring is

...Fuel Level Signal Received - Engine ...https://www.engine-codes.com > u1403'What is U1403 code meaning? ... The Fuel Level Sensor signal is a direct input to the Body Control Module (BCM). The BCM ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Chrysler Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...