Questions & Answers for: Ford F-250 fuel gauge giving false reading

fuel gauge quit working suddenly. The truck has over 200,000 miles. The rest of the gauges work fine. The gauge reads empty with the fuel pump light on all of the time. Is there a fuse to check first?

fuel gauges not registering right when i fill the side tank gauge will read full untill i drive then will drop to empty right away,back tank will read full and will drop to empty after a few days. can

Fuel Tanks reversed , Gauge not reading? My 1985 F-250 6.9 L. Diesel Super-Cab Fuel Tank Selector Switch isnt switching to other tank. with both tanks "FULL." I ran it on "REAR" tank till it was low ...

fuel pump is likely not your issue. If the basic tune up doesn't help I would remove the ignition module from the distributor (this requires a special tool). Have it checked at your local parts house,

...fuel gauge reads empty on both tanks, both tanks are full, gauge will go up to 1/4 when the key is turned off sounds like you have a typical ford gauge cluster issue.......not only have i had to ...

fuel gauge reading zero and light on ? fuel gauge just dropped to reading zero and light on. truck still runs fine. I checked for ground problem, but ??? Ford F-250 super duty 5.4 engine Ford has lots

...fuel gauge will give false readings. 02 super duty with 7.3 fuel gauge will read about 1/2 tank then after about 30 seconds drop to empty and periodicly while driving it may be on full or half again. ...

...fuel gauge is stuck in the empty potion. When I swith to the rear tank the gauge reads correctly. I am thinking the problem is in the tank and will require removal, What do you think? check to make ...

fuel gauge jumps why is fuel gauge jumping one min. to full the next to half never a steady reading Most of this type of issue is a failure in the tank sending unit. Test that for issues. Very common ...

...fuel gauge moves up tom 1/8 tank and reads low fuel on full tank, why is my fuel gauge not working correctly The fuel sending unit rod was bent during the instalation giving you the false readings. ...