Questions & Answers for: Ford Expedition fuel gauge giving false reading

...gauge suddenly climbs and oil lite comes on. Turn off engine and restart and gauges read normal. Checked temp. - okay, oil okay, replaced temperature sensor, no change. 02 sensor changed and spark ...

...fuel gauge not working Testing the fuel gage requires accessing the harness from the fuel pump and grounding the yellow / white wire with 160 ohms resistance this should cause the gage to read full, ...

fuel gauge does not read low fuel light stays on this sounds like either a short in either the fuel sender unit, fuel gauge or wiring.......hard to diagnose over the net.....more info required

...GAUGE HOSE FUEL PRESSURE 30 - 45 PSI WITH ENGINE RUNNING. THE ENGINE MUST BE OFF HOOK UP THE FUEL PRESSURE GAUGE.IF YOU HAVE TROUBLE THE FUEL PRESSURE GAUGE WILL HAVE INSTRUCTION HOW TO HOOK UP FUEL ...

...reading check. also on gauges theft is blinking on and off. if i remove the fuel relay theft blinking stops possible fuel pump shorting out problem, disconnect fuel pump wiring connector located ...

...fuel gauge has since then not been reading accurately. What could cause this? I've taken my car back three times and was told that the fuel pump was defective and they replaced it, but still the ...

...Fuel Gauge issue? 2000 ford Expedition. Fuel gauge will abruptly drop to empty and empty light will turn on but tank will be more than ½ full and drive fine. Will restart engine and gauge will ...

...gauge it could be worn out and giving the ecm the wrong information.So the ecm is getting the signals that the truck is running hot so it will shut down anything that will help it cool down.It will ...

...fuel gauge. Also, oil dip stick smells a hint of gas. Any suggestions on the problem? Did you fix the trouble Codes? Both are fuel related. There is a test done with a special machine called a "Smoke ...

...fuel pressure? The gauge shows 32psi. Sounds like a cold start problem from the description. You should check the coolant sensor circuit and the idle air control motor. Make sure the coolant level is ...