no fire Coil pack. Distributer. Spark plugs. And spark plug wires are all things that deal with the firings of the motor. the distributer cap and rotor may also be bad.
cant get fire to anny thing Try replacing the ignition components, I had one with the same problem, I rep[laced the coil, solenoid, plugs wires, and that electronic device on the distributor(just ...
...cap with a kit and i changed all mmy plug wires still no fire. It will crank over and try but no fire I would suggest starting with testing the TFI Laid out here This link also shows this more in ...
car will not get fire new dist. cap and rotor button new wires and plugs, new carburator sounds like a bad ignition module which should be on the side of the distributor
NOT GETTING FIRE IT CRANKS REAL GOOD BUT WONT FIRE Check your coils and also check your spark plugs and plug wires.
I'm looking for a diagram for a 1989 Bronco II firing order from the distributor to the spark plug 1-4-2-5-3-6 clockwise
...plug and checked to see if it was firing. There is no spark and will not fire. There is gas going to the engine and it rolls over as per normal. I was thinking maybe coil? What could it be? Sounds ...
...fire out of the carb when i roll the engine over, i put gas down the carb. and it shoots flames out of the exaust and it still wont start? i dont get it. (its getting gas so the fuel pump is working) ...
Question about 1986 Bronco II
...to the coil.check for power to plug that goes to coil but no power to them.what could keep it from getting fire to the wires that plug into the coil. This is either a wiring loom issue or a ECU
Question about 1988 Bronco II
1988 ford bronco11 have feul,but no fire from distributor to coil no fire from distributor to coil or to plugs, have replaced distributor cap, plugs,tfi module,ignition coil,and fuel filter and still ...
Usually answered in minutes!
79 Questions
354 Questions
233 Questions
196 Questions
176 Questions