Questions & Answers for: Briggs & Stratton engine quits

B & S 675 series engine timing question I have a Snapper 2550 psi pressure washer with a Briggs & Stratton 675 series engine. The engine quit and upon investigation I found the timing gear on ...

17HP Briggs Intek engine ran good then quit. Now 17HP Briggs Intek engine ran good then quit. Now won't start. Spits back thru carberater like its trying to fire back thru carberater when trying to ...

...pressure build up and if I keep the trigger squeezed it will pressure wash for about 2 seconds then quits putting out any water from the wand and engine starts to bog down??? May be it's

...engine quits after running 35 or 40 minutes. if I turn the ignition all the way off, it will start again and run normally for a few minutes before quitting again. what causes this? I have replaced ...

...to mow the lawn. mower started smoking then quit. When I got home from work I was able to start the engine one time and it smoked a lot. I turned it off and have not been able to start it. Oil leaked ...

engine start but it stops more gas in carb it runs fuel pump gives good gas flow. carb is okay, why so many problems withe intek v twin [email protected]. How long does it run before it quits?

need manual for Murray 20" cut 3.5 hp Classic push mower, Where would I find one. Thanks. This engine is one of Briggs & Stratton`s basic engines, quite a simple engine, post your problem and

...engine runs fine and then quits after getting hot as you have described, we find that ether the valves are out of adjustment or the most common problem of a bad ignition coil. Good luck and thanks; ...

engine starts but dies engine starts but quits running after a few seconds clogged carb need to rebuld it maybe needle and seat bad

...engine quits Starts and shuts down. Can push primer button and engine runs but when I stop it quits. What do I do to keep it running clean the carburetor clean the fuel line filter adjust the idle ...