Questions & Answers for: Mitsubishi Galant engine mounts

...engine mounts are bad, or could the engine just be misfiring on a couple cylinders. Is there any clunking or thumping when accelerating or just revving the engine? If there is, then check the motor ...

...Check your motor mounts, recently engine idled rough when in nuetral or stopped in drive, also jerked when put in reverse. took it to a automotive shop and found motor mounts cracked. Runs great ...

engin makes a knocking nosie in engin compartment it comes a goes noise is not consistant check and change the wishbone mount on the motor to the front end also check the lower rear angine mounts

...replacing the mounts, if they really need replacing. You can jack up the engine for its mounts, remove one, replace it, then do the same for the other mount. There should only be 2 or 3 at

ENGINE MOUNTS I have a RHD JDM Mitsubishi Galant 1998,(4cyl,1.8 ltr),auto transmission. My engine mounts are worn out. Can I use the USDM Mitsubishi Galant (4cyl,2.4ltr) engine mounts of the same year

...mounts (as long as your engine is running smooth I would not say a misfire) the mounts get a good amount of wear and tear and what happens in drive it relies on those mounts to help cushion the ...

my 2004 mitsubishi galant jerks when shifting gears, do i need a new transmission? Not really you can be feeling engine mount or transmission mounts,or even a suspension mount

engine on its mounts before tightening it down the mounts for good.  There may be shims missing to help align the drivetrain.If this vehicle has a driveshaft, you should feel any vibration in it,

...engine sides). Mounts can fail due to oil contamination, and of course, rough treatment, which you say you don't do. The center arm mounts are the most common failures, as these absorb the torque ...

...mounts. The engine might have an issue that is causing it to "shake" such as a bad spark-plug or ignition coil. Check the entire fuel and ignition system, as well as compression to make sure the ...