WATER PUMP REPLACEMENT 1990 FORD TEMPO THE EASIEST WAY disconnect the side motor mount and raise that side of the engine up with a floor jack, be very careful not to damage the oil pan.
88 ford tempo, where's the eng fan relay located. The Relay - Radiator Cooling Fan Motor is located:Under hood, driver side, front engine area, mounted on upper radiator support beside radiator
...this sounds stupid, tap the fender soliniod with a small hammer when someone is trying to crank the engine, it will start. The clicking is a jam in the solinoid, one tap and it should release. I told ...
...mounts 2.3 L engine. Helps if you have air tool's. Any way, from under neath support engine point to the mount that you will be taking off. If the front trans mount, then you have to remove the ...
...For 1990 Ford Tempo 2.3L FI 4cyl the Fuel Filter is located under hood, passenger side, front engine area, side of strut tower, mounted in fuel line assembly. Hope helps (remember comment and ...
thermostat location Follow the upper radiator hose from the radiator to the engine. It mounts to the water outlet. Remove bolts & outlet, the thermostat is underneath.
engine and transaxle You will have to be completely under it You should have at least 2 motor mounts and 1 transaxle mount The one side of the mount has to go to the sub frame or cradle I would change
could you please describe where the right rear motor mount is located? [email protected] back of engine underneath from bell housing to firewall/subframe area
How to remove right-side engine mount in order to get access to serpentine belt auto tensioner assembly? jack up motoe just enough to get the wight off mount and remove the bolt. May need a hammer.
where is the grounding wire for starter There is none. The starter is "case grounded". Starter is grounded to engine block by the mounting bolts holding it fast to the block.
Usually answered in minutes!
316 Questions
207 Questions
136 Questions
161 Questions
115 Questions