where are the knock sensor for nissan xterra 00? On 4 cyl engines the knock sensor is on the side of the block. On V6 engines it is located under the intake manifold.
...V6 engine have a non interference engine? Does it have a timing belt or timing chain? It's has a timing belt, also it's an interference engine, if belt goes bad it will bent valve's . on my xterra ...
diagram i have a 2001 nissan xterra. i changed plugs and wires. the wires are going to the right plugs but i think i have not routed the wires properly. could that be the cause of car still shaking If
...diagram available for a 2001 Nissan Xterra on where the knock sensor is located? V6 3.3L The sensor is located underneath the air intake manifold on top of the engine block. This should take an ...
...engine. The 2.4-liter 4-cylinder DOHC engine was a pretty good reliable engine, but for this truck, it was underpowered. This engine has a long-lasting timing chain - there is no timing belt to ...
what size engine is in a 2001 Nissian Xterra 2.4L 4 cyl or 3.3L V6
...engine diagram for a 2002 nissan xterra V6. I need to replace the thermostat & need to locate exactly where it is. Gotta be honest, have been a mechanic for 25+ years and have never changed a ...
Question about 2000 Xterra
...V6 engine is mounted at the rear of the engine on transmission bellhousing, the 3.5 V6 engine crankshaft sensor located at front of the engine on the aluminum oil pan section below crankshaft ...
Question about 2000 Xterra
...4:fuel pressure at spec, idling and throttle max for 1second (called gunning engine(right foot) using a tool. fuel rail pressure tests using a TOOL. 5: fuel pressure too high is FPR bad. or too ...
Question about 2004 XTerra
...engine is as follows: 11 7 3 1 4 8 12 9 5 2 6 10 It's important to note that these torque specs and sequence are specific to the 3.3L V6 engine in the 2004 Nissan Xterra, and other engine models may ...
Usually answered in minutes!
568 Questions
522 Questions
422 Questions
289 Questions
263 Questions