Frozen ejector arm My icemaker stopped working last week and when I first checked out the problem, the ejector arm was frozen to a small piece of ice in the tray slot next to the motor assembly. I ...
...main gear on the left side. Once I re-installed it filled the ice trays and the same result. The ejector blades seems to be frozen in the middle. I don't know if this is your problem but I had a ...
...breaking. I recommend replacement of the IDIM. Is there any water in the mold?? Where are the ejector blades loacted?? Are they stuck down in the mold?? Do they rotate easlily by hand?? These ...
Question about KSSC48QMS Side by Side Refrigerator
...stopped working and now the controls are beeping and flashing. Might be an ice cube stuck in the ejector. Hit it with a hair dryer. Sounds like a water flow issue. Check to make sure your manifold ...
Question about Superba Architect KSCS25INSS Side by Side Refrigerator
...ice maker, but I can still get water from the door dispenser. I have cleaned out old ice from the ejector area but nothing seems to be happening.. Any ideas? Thank you. there are two water valves
Question about Superba Architect KSCS25INSS Side by Side Refrigerator
...in the icemaker. An internal thermostat closes to begin the ice harvest cycle. A motor drives the ejector blades, and a heater releases the cubes from the mold. None of this will happen if the ...
...the ice maker mould should be @ the 10:00 position or 2:00( depends on how you are viewing) if the ejector blades are not in either position they should be in motion,no in between.if not
Question about Superba KSRG25FK Side by Side Refrigerator
Ice maker jammed. Ejector fingers in incorrect position. Ice maker jammed. Removed unit. Allowed it to defrost. Replaced unit. Filled with water. Ejector fingers moved - but not enough to eject ice. I
...works fine -- refuses to make ice cubes Your icemaker module is likely broken. Look at the ejector fingers and see if they are pointing up and slightly to the right. If not, replace module. ...
Question about Superba Architect KSCS25INSS Side by Side Refrigerator
...ice cubes are not fully ejected from the maker so that occasionally a cube gets jammed between the ejector fingers and the metal side of the tray. Any ideas? Where you say occasionally, I would ...
Usually answered in minutes!
1,098 Questions
332 Questions
312 Questions
169 Questions
102 Questions