Questions & Answers for: Chevrolet Corvette egr vacuum solenoid

Question about 1989 Corvette

1 Answer

...egr,cap and rotor,adjust throttle positioning sensor with butterfly Slimsoul, a bad fuel pressure regulator would cause a problem similar to this. You may already know this but a fuel pressure ...

Ad

...After long run it will show code 32 (egr) But the EGR works fine.... Vacuum? EGR valve could be sticking. Try removing it and cleaning it out with carb clean. Carbon buildup can cause this

Ad

Question about 1981 Corvette

1 Answer

power seat EGR i have a power seat that will not move, any ideas. thanks 91 vette also a code 32 egr light best place to start? 1981 corvette no power to the power seat need location of the fuse

...misses. Runs slow. Have replaced the computer,egr valve,and Fuel Pump. What else could it be? Sounds like the mass air folw meter sound like timing ,like the vacuum advance for the distributor is ...

Where is the EGR valve located on a 1985 corvette Located on intanke manifold. What are you doing? Typically. there is a build up in the exhaust cross over port that is centered front to back and ...

...and during sudden deceleration I would check to see if the ERG valve is stuck open. Also check the EGR vacuum solenoid. Is there any check engine like on? Here's picture of the EGR vacuum

Question about 2000 Corvette

1 Answer

On a 1981 Corvette need a vacuum hose diagram showing me where the vacuum hoses come from and connecto to on the EGR Solenoid vave. I'm looking for the same thing.

...EGR and oxygen sensor, (both replaced). also a new fuel filter, fuel pump, cleaned fuel lines and fuel rail, and cleaned and checked all injectors. Replaced the Electronic /control Module, still very ...

Question about 1985 Corvette

1 Answer

where do the three vacum line go on the egr on a 1985 corvette You do not need to connect the three vacume hoses to the EGR just find one that has vacume to it upon accelaration with the car running ...

...corvette runs rough intermintely then fine New ignition module ,fuel filters plugs ,wires cap.no vacuum leaks .runs fine sometimes. EGR sticking or mixture control solenoid on carburator if ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Manuals & User Guides

Loading...