...cycle... it stops at the drying phase and the drying phase light flashes. according to the instructions this suggests a drainage issue but it seems dry inside (well no puddles anyway) and the filters ...
cycle seems to dry for a max of 20 mins before cutting out. Have cleaned out condenser, checked that all doors of tumble dryer are closed properly, but still problem keeps on occuring. Tumble dryer is
error codes My washer dryer keeps coming up with e20 error code during the cycle of washing or drying i can't find a manual with the error codes, i have cleaned the filter so i know it can't be fluff.
cycle, there is no heat until the clothes are almost dry. hence longer drying period The heating element may be worn, or a thermostat switches off the electricity to the element cause a overheating or
dry at the end of the wash cycle At the end of the cycle the water empties but will not spin dry, any thoughts? Check the brushes in the motor. This is a normal problem. How do i get to the brush of a
...cycle Please note: in the Timed dry any time above 60 minutes will be displayed as 70, 75, 80, 85 etc. but then will be shown as 1:10, 1:15, 1:20, 1:25. For wash 'n' dry straight through... 1. Switch ...
...dry cycle . i did change the waste water pump due to another fault 6 months ago but thought i would mention it and help is greatly appreciated Hi, I've got this machine, and all washer dryers tend to ...
Question about ZWF1430W Front Load Washer
...E11 Problems with water fill in wash phase E10 Cycle PAUSED 8.2 E12 Problems with water fill in drying E10 Cycle PAUSED 8.3 E21 Problems with water drain in wash phase E20 Cycle PAUSED 8.4 E22 ...
Question about ZJD1219 Front Load Washer / Dryer
...dry on drying cycle not familar with the code but usually wash has a built in thermo stop to wait for water to heat to correct temp,if it works normally in a rince cycle and spins out and finishes ...
Question about ZJD1219 Front Load Washer / Dryer
...the door unlocks and the start button flashes - almost as it it assumes the cycle has finished. The drying function works fine though, and it was a drying function that we used before the problem ...
Usually answered in minutes!
56 Questions
31 Questions
34 Questions
36 Questions
19 Questions