Questions & Answers for: Oldsmobile Delta 88 diagnostic trouble codes

Question about 1989 Delta 88

1 Answer

...trouble shooting and diagnostic work, one other way to solve the problem without a lot of work is to go to the junk yard. Find a door that works and is obviously all there. and just replace the old ...

Ad

Question about 1989 Delta 88

1 Answer

TROUBLE CODE 18 AND 41 HOW DO YOU FIX? CODE 41 It means problems with ignition module. Remove the wiring harness connector from the module the resin that encapsulates the module circuit board was ...

Ad

...trouble codes were set and diagnosed with DOS based DIACOM OBD 1 diagnostic software running on a 486 100 Megahertz 1995 gateway laptop. After setting the TPS to .41 volts at 500 RPM in drive as ...

...trouble codes however. If you dont was to take it to have the codes pulled you can start disconnecting sensors, when you get to the faulty sensor the car may quit its eratic behavior. I would ...

Question about 1987 Delta 88

1 Answer

...to happen? No, it cannot. Is your check engine light on? If yes, please have the car scanned for trouble codes and report them to us. Autozone and Advance, among other parts stores, offer free

...diagnostic trouble codes can be read by grounding test terminal B . The terminal is most easily grounded by connecting it to terminal A (internal ECM ground). This is the terminal to the right of ...

diagnostic trouble code) lightThen you loose all stored data your mechanic needsto find & resolve any problemNo resetting,not windows 7.When repairs are complete most lights go out,some need to be

...engine control scanner or a OBD2 code reader. Once the code(s) are read then you must perform the diagnostics for each code and make the appropriate repairs based on the findings of the diagnosis ...

Question about 1988 Delta 88

1 Answer

...5L 307, ECM number is 1227076 check engine light on continiously. Not only will it not enter diagnostic mode, it is not working as it will not shift into OD. I changed the ECM unit and it's ...

...trouble codes. Your obd1, you should be able to check codes, yourself. You use a jumper wire between the A & B terminals at the data link connector, usually lower edge of dash between steering ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Manuals & User Guides

Loading...