diagnostic system is normal and will repeat itself continuously if there are no trouble codes. Otherwise, code 12 will flash 3 times before flashing the fault codes. Most of the codes can be erased or
...diagnostic system is normal and will repeat itself continuously if there are no trouble codes. Otherwise, code 12 will flash 3 times before flashing the fault codes. For GM and domestic vehicles and ...
diagnostic trouble codes for the steering system. Also be aware that there is a GM Technical Service Bulletin (TSB) # 86-32-06 for diagnosis of a faulty steering wheel speed sensor that will not set a
...diagnostic trouble codes, fuel pressure, ect.) If you have no check engine light, make sure the dash bulb works and if it does the problem is probably in your fuel delivery system(fuel filter). Take ...
...diagnostic trouble codes recorded Code P1870 is a transmission code for excessive slipage. this can be caused by allot things inside the transmission. clutch wear, seals worn out. some checking will ...
Question about 1993 K1500
...Diagnostic I (OBDI) connector is located under the dash on a 1993...And is different then the 94 you looked at...See diagram below...Is there a wire on "A" and "B"? "A" is a White/Black wire that ...
...Diagnostic Trouble Codes list? Part 1. http://repairhelpcenter.blogspot.com/2011/11/diagnostic-trouble-codes-list-for-acura_18.html -------------- Diagnostic Trouble Codes list? Part 2.------ ...
Question about 1990 K1500
...diagnostic port! with key off bridge terminal A & B turn key to on position (do not start) this will flash any trouble codes VIA the check engine light the first blink(s) are confirmation. then ...
Question about 1998 K1500
...position sensor will not affect driveability. The sole purpose of the camshaft position sensor is to provide the VCM with the necessary information for the misfire diagnostic trouble codes
Usually answered in minutes!
878 Questions
795 Questions
754 Questions
575 Questions
561 Questions