...diagnostic codes have been sent. After Code 12 has been transmitted 3 times, the fault codes, if any, will each be transmitted 3 times. The codes are stored and transmitted in numeric order from ...
...aerosol into tbi until the can runs out.Runs about 10 seconds till it dies. Over and over again. Diagnostic machine claims there are no issues. If brought inside for a few hours it will start and ...
1990 s 10. Test code is 23 ''fuel mixture''. I'm sure it a vacuum problem, however I am not able to correct it. Thanks Dan fault code 23.Inlet air temperature sensor signal showed an air temperature ...
...like blinkers etc... use a paper clip to set the computer into diagnostic mode and count the blinks to see if there are any codes set. Autozone will do it for you and print out what the codes
350 engine runs rough, low power, slight knocking, with no trouble codes - why? I'm a little confused on this one because they were only available with V6 motors and if you have a 350 cid it has been ...
my 96 2.2 auto gmc sonoma threw a code of bad shift solenoids A and B ......is that the 1-2 and 2-3 solenoids? yes they are located inside the pan at the rear of valve body.
error code 33 on 1988 gmc s15 2.5 When the motor warms up the check engine light turns on and when I drive it it turns off after a couple of feet of driving. Any suggestions? Code 33 means MAP sensor ...
autozone does not carry code reader for any vehicle from 97 and below where can iI get it read. when I start my truck the check engine light is on. Once it reaches a certain temp. the light will go ...
...it died again and now it wont run. Your best bet ,take it to a qualified repair shop that has the diagnostic equipment to diagnose the problem . You already replaced a part that didn't need to be . ...
Usually answered in minutes!
114 Questions
86 Questions
62 Questions
46 Questions