...relay in engine compartment.. 4afe or 7aFE engine? as always for ever and ever, check all fuses. check it cranking some ECU dont power pump until cranked. the ones that key on power are 3second, can ...
My security system in my Buick Le sabre is wired wrong..how do i get my car to crank To get the vehicle to crank use a remote starter switch or jump the starter relay,Use the starter relay as a tool ...
relay to power the pump.The crank sensor does not come into play until the engine is cranking and it supplies a signal for the ignition and injector pulse.Are you not getting power from the key switch
relay only closes cranking. and may not if no spark, spark is first, after fuse checks. it (relay) is only a question, if? 1: fuel pressure is zero. 2: pump is silent while cranking. if you have spark
No power going to ignition control module, what would cause this? Switch relay from the defrost relay to the run/crank relay. for the run/crank relay was getting hot. But there is still no power going
Question about 2003 ION
...cranking the PCM energizes the circuit opening relay. The PCM also energizes the circuit opening relay whenever reference pulses from the crankcase position (CKP) sensor circuit are detected. If the ...
Question about 2003 ION
I have aa 2007 chev her with 2.22 liter some of the fuses don't get power and some do on the fuse box block under hood everything to start and run car is dead 2007 Chevy her ? HHR ? 2.2L 4cylinder , ...
Question about 2003 ION
I have a 1998 buick centry 3.2 .shut it off came back out and wont click or tick.all lights and everything is working. Starter Voltage Drop Starter relay ? Transmission range switch ? IS battery ...
Question about 2003 ION
i have a 2006 chevy uplander when shut off no start batt dead and ignition fuse in bjb replace fuse and still no start or crank no power to cluster cluster dead on commute back Need better info. when ...
...cranking. the RELAY coil does that. in the relay. the RELAy coil has 2 pins, 1 on this truck 4.3 is grounded hard, other coil is PCM and is 12vdc from PCM, to coil 0v coil is dead. that is how it ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions