Questions & Answers for: cooling system fan time 2007

...cooling (radiator) fan is on all the time, from starting the engine on, until a few minutes after turning the engine off. Engine temperature is OK. No warnings on the dash. The AC is off. Could the ...

cooling fan comes on 20 seconds after car is running. I traced the fuse block to fan#3 by removing fan relay to know which fan is being told to run. it only comes on when running and not in key in and

cooling fan comes on 20 seconds after car is running. I traced the fuse block to fan#3 by removing fan relay to know which fan is being told to run. it only comes on when running and not in key in and

cooling system check and coolant flush. has anyone had the same experience? is it normal on an uplander ? Have a new thermostat installed and the radiator flushed. ( BTW,Are you sure your electric fan

cooling system in a 2007 chevy uplander If the system is not cooling, but the fan is blowing, you need to recharge the system and check the compressor. If the system is on but no air is flowing, check

...cooling fan kicks on the moment I start the engine, stops when I turn off the engine, temp gauge reads normal, check engine light is not on, thermostat is ok, flushed radiator, changed oil. anybody ...

...start but coolling fan not working and after few second fuse goes burn. You have a short somewhere causing a severe power draw. When you say cooling fan do you mean the radiator fan or AC blower fan

...cooling system and/or the engine management system. The heater fan is either directly switched and faults relatively simple to trace or subject to the whims of the climate control if fitted when a ...

...cooling fan system consists of 2 electrical cooling fans and 3 fan relays. The relays are arranged in a series/parallel configuration that allows the engine control module (ECM) to operate both fans ...

...cooling system. Refer to Cooling System Draining and Filling . Remove the intake manifold cover, if necessary. Refer to Intake Manifold Cover Replacement . Remove the exhaust crossover pipe. Refer to ...