Question about 1996 4Runner
...check engine light on a 1996 Toyota 4runner 4x V6 4x4 Remove the positive battery cable, step on brake for 10 seconds, then reconnect cable. This clears your ECM of the fault code, but will not ...
...evap code for incorrect purge flow, check the rear vacume switching valve. its above the rear sub frame po446 is a evap code for a vent control of evap system. p0441 is a code for evap purge control. ...
...check engine light won't go ogg. I checked the gas cap and retightened it and did about 15 engine starts the light is still on. I have been told to replace teh oxygen sensor. Where is that located in ...
...check engine light Hi. You can reset the check engine light by removing the blue 15 amp EFI fuse (fuse box under the hood). If you do this, and the check engine light is illuminated again, you will ...
...check engine light is on. i went autozone and they told me it was the o2 sensor bank 1 sensor 2. where is this sensor located and what does it look like? screwed into the exhaust manifolds or just ...
Check engine light is on. Autozone will do this for free. As for the other two lights, don't worry about them. They are just on because of the check engine light. They will go off when the engine code
check engine light on and runs rough at idle. I am assuming it is the O2 sensor. On two occasions on acceleration when the engine was clod, the check engine light flashed and then went back to steady.
...check engine light on and engine sometimes shuts off abruptly when car comes to a stop. starts back up with no problem. What's the code stored in the engine computer or PCM (ECM)? That's a good place ...
...check engine light keeps coming on. The mechanic says i need a Evap Canister ($464 + labor) I see at some of the parts warehouses that I can buy a Evap canister for $65. The $464 is for the whole ...
Question about 1998 Camry
...engine vacuum to the EVAP system. The ECM commands the EVAP Purge Solenoid OFF once the system has reached a predetermined level of vacuum. This test verifies if a vacuum can be achieved in the EVAP ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions