...relay circuit code. It is set if an open or short circuit is detected in the radiator fan relay control circuit. Regards, netvan P1491= "radiator fan control relay circuit". Catalitic converter fail, ...
relay coil control circuit is open AIR pump relay coil power (12v) circuit is open or shorted to ground AIR pump relay switch supply circuit is open or shorted to ground ECM has failed P2440 Secondary
Relay Circuit Open Or Shorted When monitored: with the ignition key on, battery voltage greater than 10.0 volts and the pcm requests the radiator fan to be turned on. Set condition: an open or shorted
...relay circuit Set condition: An open or shorted condition is detected in the radiator fan relay control circuit. Possibilities: Fan relay ground circuit open Fused B+ circuit open Rad fan control ...
...Relay Circuit An open or shorted condition detected in the radiator fan control relay control circuit. This includes PWM solid state relays.P1495 Leak Detection Pump Solenoid Circuit An open or ...
Question about 2004 Pacifica
...relay circuit Symptoms - Engine Light ON (or Service Engine Soon Warning Light) Possible Causes - ASD relay circuit is open or shorted - Failed Auto Shutdown relay - Failed ECM Tech Notes Check all ...
Question about 2004 Pacifica
...circuit opening relay ? these relays power the fuel pump ! The circuit opening relay provides ignition positive voltage to the fuel pump. The circuit opening relay is controlled by the powertrain ...
Question about 2001 PT Cruiser
...RELAY CIRCUIT OPEN TCM PIN 16 TO TCR OPEN OR BAD CONNECTION TCM PIN 17 TO TCR OPEN OR BAD CONNECTION TRANSMISSION CONTROL RELAY DEFECTIVE NO OUTPUT FROM TRANSMISSION CONTROL RELAY TCM TRANS RELAY ...
Question about 2007 G6 GT Convertible
...circuit. With this voltage is applied to the rear compartment lid release actuator, opening the rear compartment. Rear Compartment Lid Release Relay Ignition OFF, disconnect the trunk relay. Test for ...
Circuit Opening Relay Circuit opening relay controls fuel pump circuit. The Engine Control Module (ECM) receives an input signal at STA terminal when engine is cranking. Starter signal is also applied
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions