Questions & Answers for: how to check a coil

...coil Check the coil wire from coil to distributor cap.  check the carbon and the spring in side the distributor cup  2nd change the high tention lead from the coil to distributor 3th ...

Ad

...coil, and also check the resitances on the pickup coil. If i am right your igniter will be okay.Get a good manual for you truck, It will save you money down the road. Toyota does not have at test ...

Ad

...coil. Check the power output to the coil through its plug. Do this with a volt meter and check the pins inside the plug. A combination of two pins will result in a voltage being produced. Check the ...

Question about 1984 Pickup 4WD

1 Answer

coil check that you have power to it 12 volt. if you have efi check for a code fault when checking the coil check that there is current at both terminals to ensure current is passing through the coil.

Question about 1994 Grand Cherokee

1 Answer

check coil wire corrosion at coil terminal. if ok, check for power to coil with key in run position. if coil wire removed from coil, and engine is cranked, does it arch to ground? if does, check dist.

Question about 1996 VS 1400 Intruder

1 Answer

...coil connector, check resistance across leads, should NOT be zero, and should not be infinite, consider about 100 ohms OK. (These wear out more often than the coils.) If these three checks are OK, ...

Question about 2003 FLSTS Heritage Springer

1 Answer

...coil) and check for primary coil winding resistance which normal resistance range is 0.5-0.7 ohms. If primary resistance is not within this range check out test results below. Ignition Coil Secondary ...

Question about 2003 FLSTS Heritage Springer

1 Answer

...check the coil. Did you take the high tension wire on the coil off the distributor and ground it to the engine- and you got a bluish spark?. If you did, then the coil is working. Did you measure the ...

Question about 2003 FLHTC Electra Glide Classic

1 Answer

...coil) and check for primary coil winding resistance which normal resistance range is zero point five and zero point seven ohms. If primary resistance is not within this range check out test results ...

Question about 2003 FLHTC Electra Glide Classic

1 Answer

Coil Resistance Check In addition to the test above, you may elect to perform an ignition coil resistance check as confirmation of the coil's condition. Check the ignition coil primary coil resistance

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29492 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...