...HT lead approximately 6mm from a suitable earth and crank the engine, see if agood spark occurse, if poor or no spark occurese, change amplifier. first be sure carburator and fuel lne are clean, heat ...
...ht leads wasnt getting any response but not sure if thats the problem. I didnt think ht leads wore out or do they? what else could it be? Coil pack could be the Problem Does your tacho work? could be ...
...Change Spark Plugs * Check HT Leads * Check Battery Voltage * Fuel Filter * Get a mechanic to check your Carb settings. As i say this could be either one thing or the other but could be a combo of ...
...HT leads which i am going to fit tomorrow but im pretty sure there not going to help. anyone had a similar problem or got any ideas. Thanks Greg Change the mass air flow meter first. Hello greg Did ...
...change, check engine light has came on. Will be checking plugs first then fuel filter first thing i would do is put the old spark plugs back in and try it [may be faulty new plug] if that doesnt work ...
...change state when a magnet is brought close to the sensor head. If it does nothing, then replace it. If this sensor is bad, it will crank, but not give the signal to fire as it is waiting for the ...
Question about 1995 Millenia
...change spark plugs and coils boot the code shows again engine ic knocking and water coming from exhaust u must be using wrong plugs< make shure u are using irredium plugs code p0300 refers to ...
...change the wires on for the spark plugs they got mixed up lost track of the order please help me! Here's an image for a Mazda firing order: If you can't view the image, look on the link below: firing ...
Usually answered in minutes!
738 Questions
692 Questions
544 Questions
609 Questions
615 Questions