Questions & Answers for: catriver

getting the door inner panel off Thank you Catriver for your quick response. I removed all the screws from the inner panel and was able to lift it off except for the vent in the upper left-hand corner

Same Problem as Carmal Message for Catriver: Can you tell me the part number for a new water inlet valve for my Kenmore HE3? Model number is 110.44832.200. Thanks, FigGirl I believe you already have ...

...will not open I have the same problem as the one described below by Artweavaly. As suggested by catriver's response (second paragraph below), I went into test mode and did a self diag. After a ...

...a self test and clear the fault. The test lasts for about 25 minutes. Let us know it this works, Catriver..post back. Try high temp scrub-sani-high temp-sani. If that's not it, remove the bottom ...

flow and the top arm will not spin. Im going to try to attach a pic of the chopper assy and screen. Catriver..post back Thank you Catriver! You were in the zone! It's working like new! Many thanks

...remove a back panel to do so. I removed all bolts a screws but don see a way to remove the panel. Catriver was right on the mark. Took a little bit of doing but I was able to fix the problem myself ...

...the filter out. Clean out all the stuff and put it back in. See if the washer comes back to life...Catriver..post back Also, please check for any stucked clothe inside a washer'ssidfe( they are ...

...dryer (GE DPSR475EWOWW)and I removed the drum as explained in the June 23 note between poorman1 & catriver. I found the noise by spinning the fan from its motor and it was dragging against the

...good. If not, the thermal fuse may be blown or the ignitor itself and thus the reason for no heat. Catriver. i had the same problem, and found you can use 10 amp auto fuse for a temporary fix. heat ...

...I don't think you need the motor cover.When you receive the parts, you can contact me at catriver@npgcable.com. If you need any help putting them in I will be happy to assist you.