Lost 3rd gear Driving the car. Stopped at a traffic light. Started out, went through 1st and 2nd, but, no third gear. No previous indication of problems. Is this possible fluids problem, or hardware? ...
95 geo manual tranny have had problem down shifting to 1st gear for couple months now 2nd is getting hard to downshift and upshift have replaced rubber bushings bolts etc.on shift linkage adjusted etc
strange sway from rt rear when going over a bump hi i have a 95 prizm. every time i hit a bump or small pothole it feels like the back of the car swerves a little to the left. i believe the problem ...
wheel bearings front replace remove the wheels and then remove the hub covering and you will see a large bolt with a cotter pin, remove the cotter pin and the outside bearings will come out remoce the
its the shift stick it very wobblyand hard to change gears SOUNDS LIKE IT WORE OUT.......NEEDS REPLACE.OR A NEW KIT BUSHING AND WASHERS.......
I have a 95 Geo Metro 3cyl, It cranks fine but wont start, I checked the fuel, spark, compression, and air all look fine. I cheched the mechanical timing marks on the crank and cam gears and they look
clutch is hard to push in,the cable is o.k. the cross shaft seems o.k. bushings under clutch peddle under dash o.k., but when hooked up to Bellhousing, cable creaks. may be binding in the clutch fork ...
cant keep the car in alignment 93 geo metro convert. Grab the front tires one at a time and rock the heck out of them. If there is a loose or rocking/knocking you need new wheel bearings. More than ...
why isnt my third gear holding, it slips out if the linkage bushings are worn it might not be going into gear all the way then it would not stat in gear or a bad synro will also cause it
remove rear axles bushings bushings, there are no bushings. (bushings are baby buggy?? LOL) my guess, is you mean rear axle bearings? and seals. here iit is ...
Usually answered in minutes!
421 Questions
350 Questions
286 Questions
276 Questions
239 Questions