...I. Can you please offer any suggestions? the blower motor resistor is damaged probably in the process of removing the heater core replace the blower motor resistor, and please dont forget to rate
blower motor problems/ac problems Just recently my 2003 Chevy Trailbalzer (ext) blower sometimes does not hardly blow (heat or cold) no matter where you have the fan speed set. It will all of a sudden
...blower motor,to check this you will need to locate the blower motor under the passenger side of the dash, disconnect the 2 wire elect. connector, turn the key to the run position, now with a 12 volt ...
2006 Chevy Silverado. The #5 position on the blower doesn't work. All other positions run fine. We were told it was a relay switch. (?) YEP THE BLOWER MOTOR RELAY IS WHAT IT IS.
...Blower motor started running all the time even whe the key was removed. I removed the fuse under the hood and the fan stopped. It now works only on speeds 1-4. Is there a high speed relay replacement ...
blower motor on a chevy colorado p/u truck 2006 only runs on high speed setting The Blower Motor Resistor burned out. The resistor drops the voltage down for your lower speeds, when it dies you only 1
Blower Motor I own a 2006 Chevy Silverado 1500. When I go to turn on the A/C or heater you can hear it turn on, but no air actually come out of the vents. I believe this is a Blower motor issue. I ...
Question about American Terminal 30 i Fuses
blower motor on my 2006 chevy silverado continues to run after the engine is cut off and the keys removed...instead of disconnecting the battery i would like to remove the 30a fuse..but it looks a lot
Question about American Terminal 30 i Fuses
...blower motor relay is stuck, on your vehicle the relay is part of the blower motor resistor, the resistor is behind the glove box.I hope this helps. Take care. If you have more questions for me about ...
Question about American Terminal 30 i Fuses
...blower motor keeps running even when the key is off. Any thoughts? FRONT HVAC NOT REAR, CORRECT"? HVAC DASH? BLOWER? STUCK ON IS BAD RELAY OR CONTROLLER TO IT. MANUAL CONTROLS OPTION1 BUT THERE IS NO ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions