Questions & Answers for: Chevrolet Cavalier blinker switch

Question about Chevrolet Cavalier

2 Answers

...switch them and try it again. good luck First things first make sure your blinker bulbs are not blown if okay change your flasher relay up under the dash this usually is round and you will here it ...

Ad

...make sure the hazard switch isn't half pressed down. Some cars you can hit the hazard switch just a little so hazards won't come on but neither will the blinkers. If it's just 1 blinker change the ...

Ad

on my 1999 chevy caviler both my brake light and blinkers dont work besides the problem being the "pigs tail" what else could it be? check the turn signal switch its self the brake light circuit is a ...

blinker switch and how do i fix it? Get yourself a prob tester at autozone has a ground clip a needle and a bulb in it. test the wires. start at the bulbs and work your way to the switch or vise versa

...off then eather your switch is bad or possabily your turn signal or blinker switch is bad...check you 4 way flasher switch make sure it is off / if ajar will turn off everything check fuse and ...

left and right rear brake lights are out. center brake light comes on. rear blinkers are out too. front blinkers blink fast like a blown bulb but they arent blown. fuses are good. it sounds like you ...

...switch. Still no brake or blinker lights. Third brake light doesn't work either. Headlights and marker lights work fine. take a volt meter to the sockets and see if you get any voltage. if you don't, ...

Question about 2004 Cavalier

1 Answer

blinker eventually goes out not even lit up, then will come back on for a bit and then go out again this is on a 2004 cavalier You have either lost a ground at the taillight assembly or you may have a

...check turnsignal switch.some automobiles are designed to have the blinker stop working and the indicator burn steady on that side to show which side the bad bulb is on.could be rusty socket

...blinker/hazard/cruise control switch and it didn't work either. please the diagram attached, use the VOM , and logic sense for troubleshooting.test the buse, loose wiring, corroded , dirty. ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Manuals & User Guides

Loading...