Question about 22 hp 42" Yard Tractor YTH22V42
...blades don't When I pull up on the PTO lever the blades don39;t engage. You have a belt adjustment problem, or a broken belt. Look at the area where the belts are, you will probably see problem ...
...don39;t know where to replace them at, they engage the gears. First make sure you can still engage the blades.Many mowers use a cable attached to a spring to engage the blades.If that is one of the ...
...don39;t know how it goes Usually when someone has a problem with a lawn tractor engaging the blades it occurs because the blades are hitting the deck or the pulley shaft that connect to the blades. ...
Question about 42-Inch Steel Deck 17.5 HP Briggs & Stratton I/C Engine With 6 Speed
...i push the arm up to engage the blades, they don39;t engage CHECK BELT, WITH MOWER OFF ! . HAVE SOMEONE MOVE HANDLE UP-DOWN AS YOU WATCH THE BELT, IT SHOULD FEEL TIGHT WHEN DECK IS LOWERED .. ...
Question about 42-Inch Steel Deck 17.5 HP Briggs & Stratton I/C Engine With 6 Speed
...blades don39;t engage when i push the pto switch on dash the blades don't engage when i push the pto switch on dash Sounds like you have a loose or broken wire. It may have an inline fuse ...
Question about 42-Inch Steel Deck 17.5 HP Briggs & Stratton I/C Engine With 6 Speed
blades don39;t engage on model LT170 tractor engine runs but belts don't turn either your belt/s need to be replaced, or one of the tension pulleys either under your tractor, or on your deck
Question about 42-Inch Steel Deck 17.5 HP Briggs & Stratton I/C Engine With 6 Speed
blades don39;t ingage Engine runs great but blades don't engage when you pull the switch . Craftsman 18 hp 944606281 look and see if the belt came off the pulleys, it could be at the ...
Question about 42-Inch Steel Deck 17.5 HP Briggs & Stratton I/C Engine With 6 Speed
...blades don39;t turn the motor comes on but the blades won't turn As stated earlier it could be the shaft needs lubing, remove the bottom part of the blender blade... the rubber thing that ...
...don39;t crank I would think one of your safety switches aren't making. Could be the seat switch, neutral lever isn't made, blade engagement lever is in the engaged position and this will not allow ...
...blades don39;t engage - I don39;t hear anything when I move the clutch lever. The drive belt appears to be intact and so is the clutch cable. This model has a manual clutch 917-289344 42 inch ...
Usually answered in minutes!
1,998 Questions
1,006 Questions
778 Questions
1,057 Questions
700 Questions