Question about H3030 FloorMate SpinScrub 500 Upright Wet/Dry Vacuum
...apart and then put back together again. But pull the brush asm off, then start taking out screws. But if after you pull off the brush block, look up where you will see a small square hole, turn unit ...
Question about F7425-900 SteamVac V2 Widepath Upright Vacuum
...brush connector working I feel that I need to take it apart and see what may be broken. Any ideas? Thanks in advance, Mike Is the shaft still on the brush block, if it broke off, then replace the ...
can clean underneith. I think the brushes come out but i'm not sure how. The brush block wasn't made to take apart and clean. The whole block will come out, it just cames catches that hold it in place
...can take it apart and try to clean it out, or just replace it. Also pull out the brush block and see if the shaft that goes up into the turbine is broken off, itis broke, then replace the brush
Question about SteamVac Carpet/Upholstery Deep Cleaner Vacuum
...apart to replace the brush drive belt. Hoover Steamvac wide path spin scrub Hoover steamvacs don't use belts. If the brushes are not turning, pull the brush block out, turn the machine on and see if ...
...the brush block is turned by a turbine. Check the brush block, make sure that the shaft that goes into the turbine isn't broke off, If ok, then replace the turbine, or take it apart and clean it
Question about F7425-900 SteamVac V2 Widepath Upright Vacuum
...apart. Thanks, Robin Did you pull the brush block out to see the the shaft hasn't broken off of the brush block? If so, then replace the brush block. From the bottom, take the screws, 2 of which will ...
Question about SteamVac F5914-900 SpinScrub Upright Vacuum
...apart the spin brushes to get them cleaned out well. I loaned it to family, and the brushes came back extremely soiled and not spinning. The brush block may be removed from the base for rinsing. Yes, ...
...brush drives them all. They can and do bind up with junk and do wear down and bind. If you can't turn all 5 or 6 brushes by spinning with your fingers on the stem, the block itself could need ...
Question about C3820 Commercial Steam Vac Black and Gray
brush block did not have to be replaced. Note that the only thing holding in the brushes is the clear plastic housing around the brushes. This is a two-piece assembly held by six tabs (see https://www
Usually answered in minutes!
1,132 Questions
1,137 Questions
870 Questions
836 Questions