power. There are two base types; screw in and bayonet. With needle nose pliers try to get hold of the metal base. If it will not turn (left for loose; right for tight), then it may be the bayonet type
machine & use the other as a back up I have a mechanical & electronic sewing machine, that way if I'm servicing one I can use the other Our beloved Bernina 1090 started behaving strangely.
...machine because the dealer said I could get new disks with updates stitches. I have written to the Bernina main office. and no response. Are there disks available or how I can down load new stitches. ...
...machine repair shop & ask them about the slow response of the screen, & see what theysay & base your decision on that A slow screen response time could indicate the touch screen or logic ...
Question about Artista 180
...the old one out, leaving the old base still stuck in the bulb socket. If this is the case, unplug the machine and use needle-nose pliers to remove the old bulb base before trying to replace the
How do I reset the service icon on my 550QE The short answer is to get it serviced at a BERNINA dealer and repair center. To reset the service icon, the technician must go into the diagnostic mode in ...
...MACHINE OFF AND REMOVE THE PLUG FROM THE WALL SOCKET!!! Pull the glass globe of the light from the base. Use a dinner knife to push into the bulb base until it grips, release a little and turn ...
base of the sewing machine. To gain access to the motor, you must remove the base by removing the screws that secure it. Once the base has been removed, the stepper motor should be visible on the left
Question about Artista 180
...machine to not turn on. Check the power switch: Inspect the power switch for any damage or debris that may be preventing it from functioning correctly. You can also try pressing and holding the power ...
Usually answered in minutes!
64 Questions
435 Questions
168 Questions
165 Questions