...new cap from them. If you cannot locate the manufacturer, you can move the other cap to the windage adjustment to set the windage. Then when you're finished, move the cap back to the elevation ...
Question about Trophy 3-9x40 Rifle Scope, Matte Finish Rifle Scopes
...adjust for elevation and windage you have to take into account the daily factors (unless your shooting in the same indoor environmental controlled shooting range each day you SNOB! jk The formula ...
windage adjust correction i have a 3-9x40 deerhunter riflescope, have a problem with the windage adjust, cand you send to me, manual for repair or peaces? Go to; www.bsaoptics.com for the manual and ...
Question about Deerhunter Riflescopes Deerhntr 3-9x40 Dh39x40
...windage and elevation adjustments until scope moves dead zero back toward original target (bullseye). Fine tune from there. Air cool rifle between rounds. Once dead eye, fire another round or two to ...
Question about Deerhunter Riflescopes Deerhntr 3-9x40 Dh39x40
The reticle adjustment knob is turned all the way out (counter clockwise) and still hasn't moved the point of impact to the right enough. If you have Leupold/redfield style windage adjustable baes you
Question about ® Elite® 3200 3 - 9x40 mm Ballistic Reticle Riflescope
allow you to adjust for windage. bring the scope as close to hitting bulls eye as possible then use the scopes adjustments for the fine tuning. before remounting you will want to recenter the reticule
Question about BANNER RIFLE SCOPEPower: 3-9X40 / Reticle: Green/Red Illuminated
...windage position for? Is it to adjust sighting or to focus the scope? Why are they not covered like most scopes are The adj knobs on there are for windage on the right and elevation on the top, if ...
Question about BANNER RIFLE SCOPEPower: 3-9X40 / Reticle: Green/Red Illuminated
windage adjust and elavation adjustment it is working backwards. If your point of impact needs to move up, turn the knob the direction that says up. If it needs to move left, turn the windage knob the
...windage screws all the way so they don't block the inner tube from going in all the way. Once it is in adjust it so the cross hairs are orented correctly and put it back together. If you want to ...
Question about BANNER RIFLE SCOPEPower: 3-9X40 / Reticle: Green/Red Illuminated
...don't actually adjust cross hairs, you adjust point of impact. You do this using the turrets located near the center of the scope. the top one will adjust height, the r hand one will adjust
Usually answered in minutes!
687 Questions
481 Questions
236 Questions
236 Questions
240 Questions