...scope movement.ie.if you hit your target two inches low and you move the adjustment the appropriate number of clicks towards "up", will you hit higher or lower turn adjustment counterclockwise to ...
scope out of elevation adjustment Have tried several different rails and rings If you are sure that the scope was mounted correctly to begin with, ie plenty of elevation left THEN you can install a ...
scope body under that cap to adjust elevation. If this does not solve the problem, there is a scope repair shop that specializes in repairing vintage scopes (Ross, Ohio). This work would be beyond the
Question about BANNER RIFLE SCOPEPower: 3-9X40 / Reticle: Green/Red Illuminated
...elevation, adjustment is maxed out Bushnell banner scope, Remington model 700. Shoots 6 inches high at 25 yards and elevation screw is maxed out. Try reversing the rings. Move the back one to the ...
Question about Zeiss 3.5-10x50 Mc Rifle Scope : 5214899972
...have ready access to technical support. I fitted the scop bore sighted it. The windage click-stop adjustment works perfectly. The elevation adjustment refuses to work in either direction. The dial ...
Question about CenterPoint Adventure Class 3-9x40mm Riflescope with Adjustable Objective a
...Scope elevation is set at lowest setting and I'm still about 1" above target at 30'. I am using a center point 3 x 9 x 40 scope on a Benjamin Elite Power Master .177 cal pellet gun with a pellet ...
Question about BANNER RIFLE SCOPEPower: 3-9X40 / Reticle: Green/Red Illuminated
scope elevation adjusted allthe way up & still shoots low i have tc encore 30-06 pistol w/ tc mounts & scope, bore sighted & crosshairs low w/ elevation adjustment maxed out, windage is ...
...adjust for drop? What is the left knob for? If you have 2 knobs, there should be no left knob. If you have a knob on the left, you have it mounted 90 degrees out of alignment. Loosen the rings and ...
Question about 3-9x50 Prostaff Riflescope In Matte 6313
and elevation screws to set the scope correctly Check you mounts. If mounted properly you should have enough. if they are not moving at all you have prob broken the fine wires that form the crosshairs
Question about 3-9x50 Prostaff Riflescope In Matte 6313
...with windage or you could use two v blocks and view a point through the scope and rotate scope and adjust cross hair until no deviation from a fixed point up or down left or right Hope this ...
Usually answered in minutes!
284 Questions
229 Questions
170 Questions
130 Questions
106 Questions