auto gearchange my aerodeck 98 m.y wont hold second gear & at 5500 revs changes to 3rd gear even though it is selected 2nd gear?speed sensor fault or ?ecm??adjustment prob..with mechinism.?electrical?
96 honda will not go into gear could it be clutch slave cylinder I was driving and then I had to force the it into to gear just to get it home, what could be the problem worn or improperly adjusted ...
...are "way loose" you have bent valves. If you ck them and they are real close, just a little loose, adjust the valves while you have the cover off. GOOD LUCK. If you have no bent valves you are
...gear cover. Mark the direction of timing belt rotation. Loosen, but do not remove, the tensioner adjusting bolt and pivot bolt. Slide the timing belt off of the camshaft timing gear and the ...
vibrating gear stick when in third gear. All other gears and gear selection fine. Is this an adjustment issue? This is not adjustment it may be worn parts inside trany or on the shift arm, im not sure
sometime, when I drive using D gear, it suddenly changes to N gear. Ruling out transmission problems, you may need to have the throttle cable or shift linkage adjusted. A Job best left to Honda.
...any ideas?? Ruling out transmission problems, it could need a throttle cable or shift linkage adjustment which is best handled by
...that the clutch isn't disengaging when you push the clutch pedal in, it may just need to be adjusted or the clutch plate may be sticking or it may need replacing, try adjusting the clutch ...
Question about 1999 Civic
99 honda civic won't go into 1st and second gear after replacing the clutch after replacing the clutch on my honda civic dx 1999, once built i turned on the car and it will not go into 1st or ...
passing gear takes too long to go into passing gear and then it stays in passing gear too long no year,? a 1973 civic? id bet not.. but...... many of these cars, have 4speed, A/T some are M/T passing ...
Usually answered in minutes!
1,130 Questions
1,041 Questions
758 Questions
811 Questions
722 Questions