Questions & Answers for: adding pump oil pressure washer

pressure washer won`t pressure up engine runs good pump does not produce pressure Have you tried adding 30 wheight pump oil,under 1 qrt usually

...is for adding lubricating oil for the crankcase in the pump. If oil is coming out of it while it is running a seal in the head wore out and water is getting into the crankcase and displacing the

...pump? I just answered that question on another thread... will repeat: Oil used in engine is SAE30, I would suggest adding bit of Nulon or similiar Teflon based before even first run as it will extend ...

...pump Oil used in engine is SAE30, I would suggest adding bit of Nulon or similiar Teflon based before even first run as it will extend life of the engine, This is air cooled Honda and therefore ...

...pump needs oil added, however, I can't seem to firgure it out (how to add oil to the pump). I did notice that previously, I used to see drops of oil coming from under the pump. I I have a bad seal, ...

adding pump oil to Husky HU80709 Pressure washer where do you add oil & how much to pump on Husky HU80709 pressure washer? If it has a radial pump, tall models have radial pumps and don't have an ...

...oil level in the pump and it appears to be bone dry. The manual calls for 75w/90 non- detergent oil but does not tell me the quantity the it holds. 1) Is there any way to check the oil level in the ...

...Pressure Washer. was sitting up over the winter, now it won't start. The problem most people encounter with lawn mowers, weed eaters, and pressure washers is that today's gasoline has so many ...

...milky when its time to replace it an allways ck your oil level in pump and engine an refill if needed when adding gas to tank , its natural to be missing some each time as equipment gets older an ...

...pump oil? https://www.youtube.com/watch?v=XGifDw_Vs_Q owners manual below https://www.manualslib.com/manual/796394/Pacific-Hydrostar-98444.html?page=19#manual ...