How do I add Cruise control on a 1.8 sri 60 plate Cruise control not fitted not sure if wiring is in place When you buy the cruse control all the wireing should come with it plus instructions
Question about 2010 Zafira 1.8
...stage 4. +90 degrees stage 5. +45 degrees Engine code C14NZ 1993-1998 Stage 1. 25Nm stage 2. +60 degrees stage 3. +60 degrees stage 4. +60 ...
...is about 80 degrees the starter motor does not operate until engine hascooled down below 60 Degrees Maybe cranckshaft sensor!!!? Hi there. Your starter motor itself is shot. Your symptoms ...
Question about 2008 Zafira 2.2
...could you help me out with the big ends, mains and flywheel torque settings for a 1995 opel astra 160ie Main bearings stage 1 50nm stage 2 45 deg to 60 deg no flywheel info except clutch to flywheel ...
Requert torque settings for a 1982 opel kadette. Thankd about 60 psi as i seem to remember
Torque settings bearing cap corsa 1.2 16v Hi there new bolts has to be used M6 mm 1st 10NM 2nd 60 degrees 3rd 15 degrees M6.5 1st 13NM 2nd 60 degrees 3rd 15 degrees
Question about 2008 Zafira 2.2
...outward spiral pattern the bolts are then further tightened in four stages that is something like 60 degrees + 60 + 30 and then after thoroughly warming up the engine and allowing it to cool for at ...
...outwards in a spiral pattern is 18 lbft. This is followed by further tightening in stages of 60 degrees + 60 + 60. After thoroughly warming up and allowing at least 6 hours cooling time the ...
...in a spiral pattern.The bolts are tightened first to an initial torque of 18 lb-ft and then by 60 degrees + 60 + 30 degrees and then after thoroughly warming up the engine and at least 6 hours ...
Question about 2008 Zafira 2.2
...torque of 18 lbft. As an example, many of the 8 valve Vauxhall/Opel engines are then tightened by 60 degrees + 60 +60 and then after a thorough warm up and at least 6 hours cooling the bolts are ...
Usually answered in minutes!
57 Questions
54 Questions
29 Questions
29 Questions
43 Questions