2002 Pontiac Grand Am, I need to remove and replace the REAR Brake Pads, I am confused as to what type and size of a socket I will need to remove the bolts that hold the caliper on, I`m told It may be
Question about 2001 Grand Cherokee
...Grand Cherokee - 6 cylynder I'v tried 3/4'', 11/16'', 12 mm - always slips off What is your question? You have metric tools. Are you missing a size ? Which nut? Caliper mount or brake hose. Or torx ...
...grand cherokee 4 wheel drive V8. there probably is not much difference between year models. frist thing remove the back tire you will see the caliper and rotor. check the rotor if it has deep groves ...
Question about 2002 Grand Cherokee
2002 Jeep Grand Cherokee Laredo 4.0L front passenger brake sticks 2002 Jeep Grand Cherokee Laredo 4.0L The front passenger side brakes are sticking closed causing heat buildup, poor gas mileage, and ...
...2002 Jeep Grand Cherokee. Where are the bolts holding the caliper and what size socket is needed? They may not be bolts, might be the allen wrench type, on the back side of the calipars, one on top ...
...Grand Cherokee 2001 8 cylinder 4x4 10 mm socket to remove the caliper slide bolts, a decent sized screwdriver to pry the caliper up off the rotor and a large "c" clamp to drive the piston back into ...
...jeep grand cherokee laredo If you mean to remove bolt, they are a metric allen size. To replace, you need a special pin / sleeve type bolt, available in sets at the auto parts store for around
...2002 grand Cherokee need to replace pads and rotors, but can't get the calipers off. Is their a special tool to get the pins out? You don't really have to remove the caliper pins to replace ...
Question about 2002 Grand Cherokee
2002 Jeep Grand Cherokee 2 wheel drive Replace Front Wheel Hub Bearing 2002Jeep Grand Cherokee 2 wheel drive Removal Raise and support the vehicle. Remove the wheel and tire assembly. Remove the brake
Question about 1993 Grand Cherokee
what size is the bolt in the harmonic balancer in a 1993 jeep grand Cherokee larado 5.2 liter bolt size i posted this yesterday 1-1/4" or 32mm buy and use a caliper to measure bolts.
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions