...break in the connection to the steering wheel mounted airbag, this is due to a rotating ribbon contact that breaks under the steering wheel that connects the airbag to the wiring harness and the ...
...Maxima i have tried to push the piston back and hold it with a thumb nail,then rotate the engine 20 degrees to give it slack but i still cant remove the waterpump. Now I'm trying to remove the timing ...
...nissan maxima? i dont think its a factory but theres no way to get to it without breaking the panel just push up on the clock part you wont break it, the pull down once it pops. unplug defroster and ...
Question about 1997 Maxima
Nissan Maxima Break lights and signals work....what fuses should I check to see if they are out for tail lights, tag light and dash board? If you don't have a manual, just get a test light, and ground
...break lights still on. I don't understand but I think your help will be very very appreciated, and tell ne if it is safe or not to drive my car. Thanks It sounds like your brake light switch is stuck ...
...LIGHT TURNED GREEN I LET THE BREAK UP AND PROCEEDED TO PRESS ON THE GAS AND THE CAR WOULDN'T MOVE. I HAD TO TURN THE CAR OFF AND ON AGAIN TO GET IT MOVING. WHAT COULD CAUSE THIS? It may be the ...
...is good? Try the voltage regulator. Buy test light and you need the wiring diagram. You are going to have to find the break in the circuit Sometimes its worth looking around the neutral safety
1 - Cannot get brake lights to go bright wen i push down on the break pedals. 2 - Acceleration stops at a certain point, in order for me to get the car to go up to speed i have to push further down on
Question about 1997 Maxima
My brake light on the left-hand side would not come on when pressing the break on a Nissan Maxima 1997 More than likely the bulb is blown. Open the trunk. You acess the tail & signal lamps from there.
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions