1997 Jeep wrangler the horn stopped working on my 1997 jeep wrangler and at the same time the airbag light came on and I can't figure out the problem Clock spring mech is prob bad, first easy check is
...Jeep Wrangler High Beams Work, Low Beams dont I have an 05 Wrangler and the high beams work, but the low beams dont. I have already chaged the bulbs (same thing happens), checked all fuses (they are ...
...JEEP WRANGLER PROBLEM: FRONT PASSEGNER TURN SIGNAL LIGHT DOES NOT FLASH, HOWEVER WHEN YOU PUT THE TESTER TO IT, IT DOES FLASH....STUMPED. SIDE TURN SIGNAL IS WORKING FINE. HAVE INSTALLED A NEW BLUB ...
Question about 1997 Wrangler
...Jeep Wrangler Dash Gauges Arent Operating..everything else ok! This little problem seemed to come out of the blue. I started the jeep up and the gauges were all dead...speedometer, tach, fuel, ...
Wrangler Rubicon and the rear right brake light and blinker stopped working. I tried to replace the bulb and fuse but it still doesn't work. Any suggestions? If it's a wiring issue, please be specific
...1997 it is a 175 Amp Mega Fuse mounted on the outside of the high voltage fuse box located on the drivers's side in the engine compartment. After replacing the battery and the Alternator, it turned ...
...side turn signal. Best way to check them is to turn on your hazards look at the front to see if there is one flashing on the right that is not on the left, then do the same with the back. You should ...
Question about 1997 Wrangler
...jeep cherokee sport . when i put high beams on, The pasg side headlight not working,but when on low beam both lights work. ?i changed headlight and it did the same thing with new headlight. You have ...
Question about 1997 Wrangler
why does my front blinker light comes on but does not blink, but front side blinker light works I change bulds huh? there are 4 corners, what works and what dont. blinks and hazards. ????
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions