Questions & Answers for: Mitsubishi 12 volt relay

Question about 2006 Endeavor

1 Answer

heater/air conditioner blows no air on any setting check for power(12 VOLTS) AT THE BLOWER MOTOR WIRING. IF YO HAVE POWER YOU NEED A NEW BLOWER MOTOR. IF NO 12 VOLTS YOU HAVE A BAD FUSE OR RELAY.

Ad

...relay. If you do hear the click, your horns have likely failed. You can check for 12 volts with a multimeter or test light on the horn wire when the pad is depressed to verify. If the relay and fuse ...

Ad

...12 volts or any volts you need to make sure the fuse and relay for the starter are good then check and make sure you have power coming out of the ignition switch going to the starter you will need an ...

...fan motors are OK, How do I check the sending units and relays? the sending unit will give an output reading of 12 volts to the relay. If the voltage is currently going to the relay replace the ...

...12 volt to fuel pump and ignition coil. go to the dealer and ask for the diagram for pcm relay and read it carefully or ask a friend to help you. check the fuse that supply 12v to the relay. mechanic ...

Question about 2001 Eclipse

1 Answer

... How can I solve the problem some cars have a 24 volt starter motor but the rest of the car runs on 12 volts,,,there is a relay to switch over to 24 volts only for starting the motor ,,,check the ...

...relay, or fuel pump problem Check the power going to the fuel pump. If it gets around 12 volts when the key is turned to the On position, replace the fuel pump. If the fuel pump is not getting around ...

...relay you should have 12 volts at 2 slots terminal 30 has power all the time terminal 86 has power when then computer tells the relay to turn on fan, for cooling or a/c, terminal 85 is ground(-) for ...

Question about 2000 Galant

1 Answer

...12 volts at the pump, the amount of fuel flowing may be much less than expected and perhaps enough less to create lean air-fuel mixtures under heavy boost. The instructions below show you how to ...

...In the front engine control unit (ECU), the taillight relay may be defective. There should be 12 volts on pin 8. Next, check 7.5A DEDICATED FUSE 20 for 12 volts. Check the lamp sockets for

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Mitsubishi Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...