Questions & Answers for: 12 volt relay

Ad

Question about 1999 Ram 2500 4WD

1 Answer

...4 connection of relay,pullout relay,check if there a 12 volts supply,, a 12 volt control by ignition sw.,connection to blower motor, the last connection is to the switch mostly connected to

Ad

12 volts. fuse and relay is good. on my 1994 plymouth voyager the 3 wire harness to fuel pump (blue wire) doesn't have 12 volts; should it? fuel pump quit then worked once when hot-wired with 12 volts

Ad

Question about 1999 Grand Voyager

1 Answer

...help Pull the relay and make sure you have 12 volts there. Pin # 30 is the power to the pump. this will tell you which way you have to go to find a short or corrosion in the wires. let me know ...

...relay....+ 12 volts from the PCM ABS fuse (10A)...via Park/Neutral switch to crank relay...Relay pulls and applies +12 volts on the Purple wire that goes to the starter...That +12 volts, if ...

12 volts to the Pump? i had the same problem, its the fuel pump relay, pull the relay, pop off the plastic top, insert a shim so that the points are always touching, the other thing it could be is the

...relay input to the PCM. Fuse #12 (10amp) provides 12 volts to the coil side of both the relays and the ignition switch. Fuse #6 (30 amps) supplies 12 volts to the output side of the relay. Fuse #16 ...

...dodge grand caravan 3.3 what is the coil voltage in the cooling fan relay? 5 volts, 8 volts, 12 volts. The cooling fan relay draws 12 volt power through 40A fuse 106 in the power distribution ...

relay. Applied 12 volts to fuse socket with ignition s Checked battery, checked fuses, all good. Not getting 12 volts to 5 amp fuse for starter relay control circuit in any position of ignition switch

...12 volt dc power source and connect the negative to the relay ground, and the positive to the relay input voltage lead. When 12 volts is applied to the input voltage, you should hear a click of the ...

Question about 2007 Explorer

1 Answer

...12 Volt probe {google it} can be a cheap checking tool for this. If 12v volts is switched when button is pressed {could be earth being switched if it is then place probe on constant 12 volts and ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

Marvin
Marvin

Level 3 Expert

85216 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

john h

Level 3 Expert

22486 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...