I had this problem. I tried to interupt a cycle just after it started and then couldn't start the cycle again, with the E27 code coming up. e27 refers to a problem with the door locking mechanism which could be due to a number of causes. The problem I had was with the solenoid in the door, not a genuine problem with the door latch mechanism. Here is how I fixed it: (1) Set knob to off (2) Hold down spin selector and Allergy rinse buttons and turn the knob to the LEFT (right does not work) (3) The display then shows a number of program codes P01 to P14. (Pressing spin selector rotates through the codes). (4) Press spin selector until you reach P02 on the display, then press the start button, the door will click and the machine will begin a cycle. (5) Turn the knob to OFF, and then you should be able to use the machine as normal.
E27 is a door lock error. Couldn’t find e95 listed.
What is a code e95
SOURCE: I have a Bosch Vision 500 with a few error codes.
E-27 means you have a bad door lock. Try opening and closing the door.
You can remove the lower front panel of the washer. There is a white
plastic cord that hangs down by the drain filter. Pull the cord and
pull out on the door. It is the manual unlock for the door. By pulling
this you may reset the lock. If not you will have to replace the door
lock.
If this isn't work, replace the door lock assembly and you can get it at a local appliance parts dealer near you with the model number. Also, could read this article about Error Code E27 for a Bosch Washer.
E-01 code indicates a ventilation problem. Other details in Bosch-error-codes.
E95 isnt listed, stay looking.
A code E27 means a problem with the door lock. Try
unpluging the machine for an hour and see if it resets the lock.
If not remove the cover on the lower right
corner you will see a white plastic pull cord. Pull the cord and pull open the
door. If that doesn't reset the door lock you will need to replace the lock.
2,981 views
Usually answered in minutes!
×