How to remove motor from bosch wfo 2867 washing machine@?

this is probly the motor carbon brushes remove motor and check brushes they should have a nice shine on on the face if not there needing replaced wear length is about 15mm new they are approxx 25mm long

there is a thermal cut out located in the windings on the motor you may have o hunt for this it has a wire going in and n out, you could short it out as a quick test if motor running....

sound like the motor brushes are worn out, just remove motor and fit new brushes. nice easy repair

I suspect that the brushes in the motor need replacing, remove the motor and replace brushes if less than 4 or 5 mm long.

I would suggest that you remove the motor, and check the brushes for wear.
If they are less than 3 or 4mm long, then they need to be replaced.
Hope this helps.

My old Bosch only had a filter in the machine (where the hose attaches. My Exxcel has a filter IN THE HOSE at the tap end too. I removed that one and it made a big difference !

The filter is usually located at the bottom right front of washer, sometimes behind a removeable cover, or a drop down flap.If you can locate it, then unscrew it anti-clockwise to remove and clean it.
There is also a possibility that there could be a hole or tear in the door seal so check the seal as well.
Hope this is of some help to you .

please tell me somebody how to turn off spin for bosch WFO 2442?

Remove rear panel of washer.
Undo 2 screws securing motor to tub.
Pull motor plug from terminal block.
With a screw driver, or similar, lever back motor, keeping hold of it , and remove motor.
Fit new brush.
Please rate my fixya solution.
Thankyou.

u can sometimes tip the washer backwards and with a torch u should be able to see the carbon brushes and the 2 star screws which hold them in undue these screws and the carbon brushes will pop out very easily for u to change them m8