At my hospital in the dialysis ward, there are DGM televisions which receive a signal from a central freeview source. I tried to program my controller for one of these sets by using the DGM code 2059 given in your code book but to no avail. I then tried using other codes that the hospital have, namely 0310 2239 2295 but to no avail. I then tried the search method but again no luck. I even tried to copy the codes from the DGM controller at the hospital but the only success I had was to copy the ON-OFF function but no other of the buttons.
When trying to program, I get the double blue light on the controller as stated in the instructions but the TV does not switch off at the end when it should. Am I doing anything wrong or can I try anything else? Thank you.
Laurence Ben-Nathan
[email protected]
TLA-01911C and UEI OneForAll URC-3021b00... Code 0178 worked for me, except that the up/down right/left keys also worked channel and volume (as well as the channel and volume keys), so I couldn't navigate the menu. No keys to choose input.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Roy, change your cable, must be faulty and not giving a signal to TV.
"I hope this helped you out, if so let me know by pressing the helpful button. Check out some of my other posts if you need more tips and info."
To watch anything on the Tv it needs a signal source, which is either via an aerial or a broadband service provider like Cable network like Time Warner or Satellite dish or even fiber optic service provider like Verizon.You cannot use your TV without these signals. So you do need an aerial to be connected to the TV.
my tvs saying no signal and ive tryed the source button when i was watching freeview it com up with a system update and nothink happend and now says no signal
If you want to watch Freeview, then you need an aerial, preferably a proper external (or loft mounted) one. Freeview signals are far weaker than traditional tv signals and so trying to receive them without an aerial or via a tv set-top aerial is usually doomed to failure. If you must use a set-top aerial then connect it directly to the tv (not via a video or any other device) and avoid using "amplified" or "booster" aerials unless you have no other choice.
I'm unfamiliar with Vistron, but usually channels are added by going into the menu and looking for "installation" or "set up". But if you have no aerial then you aren't going to get very far.
HD Ready just means the tv can display HD images from an HD source.
The built-in Freeview box on your tv is not Freeview HD compatible so you'll either have to buy a separate external Freeview HD box or subscribe to an HD satellite or cable service.
In any case, most built in Freeview receivers are of barely adequate picture and reception quality. An external box is usually far better in both respects.
Have you done a channel search on both tv sources(atv and dtv). most new tv's will automatically start will "New Install". If you havent had a digital installed recently then this could the problem. set top boxes and TV's will pick up the signal ok but others wont.
Hi
My dear friend this is not a forum where you can get source codes.
Better try sourcecodes.net or planet-source-codes.com and others for these codes.
×