After being moved quit working - Kenmore 53642 / 53644 Side by Side Refrigerator

It could be loose wires or bad controllers

Hi, if you move the cluster may you move the switch from your steering wheel check you steering switch is on the right fitting.

Check and replace its main power regulator board.

Have you tried replacing the battery?

if one or the other quit working and then both quit working then i would have to say by looking at the electrical diagram that it would be the speedo head itself. it sends only one signal to speedo head that the vehicle is moving so if one was working and not the other then the sensor in the trans should be doing its job but if both had quit at the same time i would say sensor in trans. good luck hpe this will help you let me know...................

change your clush plate or gear if its in place

if your set is like my old one the skaters move by magnets underneath the rink. If yours is the same you may try removing the rink and oiling the tracks that the magnets move on. This worked for us

Reinstall the driver software and keep pressing the scanning button for 3-4 times to move the scanning head.

check ou microphone jack in the back

moving it on side might empty gearcase oil, any yellowish oil drippin gout of anywhere? hard to tell about hte metal movig around, its quite normal for machines to move around quite a bit on the inside