- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
If your Kettler Marathon ST treadmill is stuck at the blinking HR (heart rate) screen and is unresponsive to button presses, here are a few suggestions you can try to troubleshoot the issue:
Check the safety key: Ensure that the safety key is properly inserted into the console. The treadmill may not respond if the safety key is not properly engaged.
Reset the treadmill: Locate the power switch or unplug the treadmill from the power source. Leave it unplugged for a few minutes to allow the internal electronics to reset. Then, plug it back in or turn the power switch back on. This can sometimes resolve temporary glitches or errors.
Inspect the console connections: Open the console cover and check the connections between the console and the rest of the treadmill. Make sure all cables and connectors are securely plugged in. Loose or disconnected cables can cause communication issues and affect the functionality of the console.
Clean the console buttons: Over time, dirt, dust, or debris can accumulate around the console buttons, preventing them from registering presses. Gently clean the buttons and the surrounding area using a soft, lint-free cloth. Avoid using liquid cleaners that could damage the console.
Perform a console reset: Look for a small reset button or hole on the console. Using a paperclip or a similar object, press and hold the reset button for a few seconds. This will perform a console reset, which may resolve certain software or configuration issues.
Consult the user manual: Refer to the user manual or documentation that came with your Kettler Marathon ST treadmill. Look for specific troubleshooting steps or contact information for technical support.
The motor or the Motor control board is faulty. Can be the motor brush or the shorted igbt transistor in the motor contol board. If you wish to get some more details about treadmill repair then check the following link. http://electro-medical.blogspot.com/
adjust the speed sensor, see the diagram attached, clean, and tight the wires connector very well. 2) Test the input voltage motor, if there are the motor need repair. 3) Tes the output voltage board, for input voltage motor, if there are NOT the board is faulty.l
After you did, RUN the software calibration for diagnose, troubleshooting,and fix it.
Sounds like the function keypad has failed or worn out from excessive use of those buttons Call Kettler's customer support
KETTLER International Inc. P.O. Box 2747 Virginia Beach, VA 23450 USA
Tel
(757)427-2400
Fax
(757)427-0183
Email[email protected] or www.kettler.co.uk
Your treadmill needs lubricating.
Get a an aerosol with silicone lubricant and spray it under the belt & on top of the ground board.
Then turn the belt by hand (treadmill switched off!) until you've lubricated the whole belt.
Next leave the machine running for 5 minutes at 5 KM/H (3 M/H) without any load on it.
×