I have Invicta 0764 watch and it is great. However I have some problems with day adjustment. First of all, crown does not have two adjustment positions, only one. Invicta instructions ****. I do not want to rip it off, because it "clicks" only once. There is small button which I can use to adjust date by clicking it when crown is out on "adjustment" position. By turning crown I can change time. Problem is how to change week day. It shows Monday when it should show Tuesday.

Depending upon the movement, most pro divers have a *****-down crown for water tightness. First unscrew the *****-down crown. You can then pull the stem out one or two clicks. The first click permits you to set the date by turning the crown one way or the other. The second click should permit you to adjust the time. Then push the crown back in, hold it down and ***** it down 4 water resistance. Be gentle when manipulating the crown and stem!

Pull out the Crown half way to adjust the Date, all the way adjusted the Time.

Divers watches usually have to have extra strong seals to prevent water getting in. This often achieved by screwing the crown wheel (to the right?) after it has been pushed home.

To pull the crown out, first rotate it anticlockwise about 1/4 of a turn and then pull.

Most good dive watches with a screw in crown need the crown to be pushed in and turned clockwise AT THE SAME TIME in order to screw in the crown fully and make the watch watertight.

When you want to adjust the date or time, you just rotate the crown counter-clockwise until it pops out a bit. If you gently pull the crown out to the first position you can turn it to adjust the date. If you pull the crown out farther, to the second position, then you can turn it to adjust the time.

Never take your watch into the water unless the crown is fully screwed in finger tight or water will get into the watch movement compartment and ruin it.

Good luck, hope this helps.

mcdevito75 here, Your invicta may have a screw down crown that adds water proof protection to your watch, try to un-=screw the crown when un- screwed then pull up to set time.

If your lupah has a screwdown crown (middle button), you need to unscrew it. Pull out the middle button 1 click (it should have 2 clicks...if it's all the way pulled out, then you have gone too far) and turn the screw counter clockwise. Some model's you have to give them a couple good turns to adjust a single day, so don't give up if you move it a quarter turn and nothing moves. Once done adjusting, just push the crown back in and lock it down (lock down crown isn't a necessity. It is rather a means of keeping water at pressure from entering your time piece. So don't freak out if your model doesn't have a screwdown crown. Not all of them do). Best of luck to you!

Hi Friend,

Please check with the below link,which gives the detailed information about the Invicta Watches.How to set the Date and time in your watch.

http://www.invictawatch.com/support_files/instruction_manual/Manual-HiRes.pdf

If you have any Clarification please write back to us

Regards,
Aysaam

For Invicta chronographs to set the day you need to pull the crown out to position 3 (2nd click after releasing the crown/ furthest crown position/ same position to adjust time). You can only set the day by rotating the crown clockwise. Every 24 hours of clockwise rotation will move the day indicator forward 1 position (Mon>Tue, Tue>Wed, etc). If your watch is set one day ahead of the correct day (Its Tuesday but the watch displays Wednesday for example) you will need to rotate the crown clockwise through the entire remainder of the week in order to get to the correct day, you CANNOT rotate the crown counter-clockwise in order to move the indicator back a day.

It can happen to ANY watch! Take it to a reputable watch repair shop and let them fix it....just needs some loctite but the stem needs to be removed from the movement so the crown can be correctly put back on!