Spisn cylce will not spin all the water out. - Maytag Neptune MAH5500B Front Load Washer

you may have a faulty water solenoid

if the washer is a Whirlpool brand then it is likely the coupling between the motor and the transmission.

Twist timer very fast a few times and stop it on spin with the lid closed. Wiggle the timer to get the points to connect. Even if you
just get a little bump then its the timer.
If none of this works then it is the timer plus maybe something else contributing.

Don't forget to check the lid switch plunger on the lid

If this was helpful please rate me.
IMUFO2
Leo Ponder Appliance-Tyler,Texas
[email protected]

cheng or check the buord

My Maytag Ensignia washing machine leaks large amounts of water when filling and during spin cylce. What could be wrong?

error codes for whirlpool
http://www.assuredparts.com/WhirlpoolDuetWasherFaultCodes.html


good luck bruce

the fill valve is an electric magnet valve and sounds like it is stuck unplug machine disconnect water lines plug in and when u turn on does it click, if yes then unplug try to slide a long qtip in and if it goes in replace valve

cold water screen in hose was half plugged causing it to either shut off the spin cylce due to lack of water or increase the spinning speed.
Hope this solves the problem.

that could be your problem or your drain pump maybe full... try spin and drain see if it will drain

The spin normally does not work when the outlet filter is clogged; if the filter is clean you should then check your pipe coming out from under the tub (plug off the wall first before doing all these things). Last check your outlet pump, could be blocked with something. Refit carefully, you might need a nice pair of pliers to get the grip clip on and off the pipes.
The outlet pipe into the wall stands at a particular height, refit exactly to this height, about 3 feet from ground