Question about Ryobi Garden

1 Answer

I need the fuel/oil mixture for Ryobi 31cc 775r gas weedeater. Also the diaphram for the fuel line replacement.

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Ryobi Master
  • 1,545 Answers

The fuel/oil mixture is 40:1. That is 3.2 oz. oil/US gallon. Now for the fuel lines:

The small diameter line out of fuel tank (has filter in-tank on end) connects directly to the side of the carburetor that has the fuel pump....that is the cover without the hole in it. Other larger diameter fuel line out of tank connects to the longer nipple on the external purge/primer bulb. The bulb "pulls" fresh fuel from the fuel tank to the carb and then out of the carb to itself, where it then "pushes" any air/old fuel back into the fuel tank. The remaining larger diameter fuel line in this setup goes from the metering chamber (has cover with writing on it and a vent-hole) side of the carburetor to the smaller nipple on the purge/primer bulb. Again, on the primer bulb, the longer nipple has a line going directly from it to the tank. This is the return line. The shorter nipple on the bub has a line from it going to the metering chamber side of the carb. If the purge/primer bulb is on top of the carb...small line from carb body to small hole in tank with filter. Larger diameter line goes from the bulb on the fuel pump side of the carb to the larger hole in the fuel tank where sometimes the line is held in place with a nylon nipple connector that keeps the line from pulling out of the tank. Otherwise, the line should enter the tank for about 1/2" or so.

Posted on Jan 11, 2011

Ad

1 Suggested Answer

Anonymous

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

Oil and gas mixture


Mixture is typically 40 or 50 to 1, gas to oil. The exact mix should be stamped on the gas cap.

Apr 10, 2010 | Ryobi 15" Electric Factory Reconditioned...

1 Answer

Need a diagram that will show the tubing feeds on ryobi weed trim


If you need a fuel line diagram for ryobi 775r let me have your email address.
tony

Oct 13, 2009 | Garden

1 Answer

Putting fuel line on right on ryobi 725r 15'' 31cc weedeater


Typical fuel line routing is:

One line (the one with the fuel filter in the end of it) comes out of the fuel tank2.gif and goes to the bottom fitting on the carburator. The second line comes out of the tank and goes to the bottom fitting on the primer bulb. The third section of line goes from the top fitting on primer bulb to top fitting on the carburator. Hope this helped and best wishes.

Sep 08, 2009 | Ryobi 30 Cubic Centimeter Curved Shaft Gas...

1 Answer

RYOBI weed eater.hard to start. starts then stops


I have a ryobi doule line bought in 1997..Had same problem put new gas cap on and problem solved..could not get air in....

Aug 01, 2009 | Ryobi Garden

1 Answer

MY RYOBI 31CC 775R WEEDEATER WON'T START I REPLACED THE SPARK PLUG AND STILL NOTHING I DON'T THINK ITS GETTING GAS HOW DO I FIX OR REPLACE GAS LINES.


spary a little startingfluid in carb to see if it start if it start rebuild carb.to change fuel line
only if there dryrotted if it go thourght the gastank in little hold cut new line on a angle and thread through hold.hope helps you.let me know ok

Jul 24, 2009 | Garden

2 Answers

How to remove drum connector off ryobi weedeater


I believe there are four phillips headed bolts around the outside edge of the housing

Jul 23, 2009 | Ryobi Garden

3 Answers

31cc ryobi weedeater wont start


I've had similar trouble. I removed the plastic cover to expose the fuel lines. I've had to replace all of them as each one had dry rotted, split or had holes. There are four runs of clear plastic fuel line. Check all your lines and then check for any of it being plugged up to the carberator. The primer bulb should develop some pressure when all is good.

Jun 14, 2009 | Ryobi 30 Cubic Centimeter Curved Shaft Gas...

1 Answer

RUNS AND STALL WHEN YOU GIVE IT GAS


you are right on. try richer mixture.

May 22, 2009 | Ryobi Garden

2 Answers

Blowing gas out the air intake


Eight years is great for a weedeater! Blowing out can mean something is stuck in the reed valves, or one may be broken. They are just under the carb, usually. Be real careful with the gaskets. If you mess up any, silicone will do. Use good car gasket silicone.

Apr 30, 2009 | Ryobi 30 Cubic Centimeter Curved Shaft Gas...

Not finding what you are looking for?
Garden Logo

Related Topics:

1,018 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ryobi Garden Experts

Nick Olsen

Level 2 Expert

196 Answers

Wayne McNeil

Level 2 Expert

209 Answers

Thomas F. Schneider

Level 3 Expert

2715 Answers

Are you a Ryobi Garden Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...