I cannot login to my SG20... I bought this as a working unit from a city in Colorado, but have been unable to login to the admin features. I have tried port 8282, currently the device displays that it's ip address is 192.168.0.250, but that does me no good either -- ANY HELP is GREATLY appreciated.

The login and password is admin.

The default admin username is "admin" with no password.

The default adress is http://192.168.0.1

If you are still unable to connect, the password may have been changed. Reset the router with the button on the back, and try again.

If it was unplugged for any period of time, it is probably reset to default settings. Password is default, etc and you are trying to access with the wrong credentials.

Try resetting it manually and starting as if you just purchased it, if you continue to have problems. There should be a reset button or procedures on how to reset in the documentation.

the administrative features are accessed through feature 983 with a default login of 1020000 (if your using 3 digit intercom numbers).

Open your web browser and type the IP address of the TEW-450APB in the address bar. The default IP address is 192.168.1.1. At the login, enter your username (admin) and password (admin).

The default IP is 192.168.1.1 and not 192.168.1.100 as you have entered.

Hi,

In order to Unlock Netgear router you need to know the login password for router's login page and if that does not work, you can try with a default username : admin, Password : admin, still if you are unable to access the routers page then you need to reset the router by inserting a pin in the pinhole where it says reset at the back of the router...press and hold down the pin for 30 seconds and then restart the router, this will take the router back to default settings and then apply username : admin and password : admin....it should work

Netgear address : 192.168.0.1 ( Type in IE address bar to access it )

Regards,
Anup

http://www.securecomputing.com/techpubsRC.cfm

Your image is corrupt from an improper shut down. I had the same problem. Reinstall default .TIB and it will boot fine.

Press reset button on back of unit AFTER system has fully booted (time will be displayed) and your system will be back to default values - password = applianceadmin.

You can also re-image the drive to factory defaults.


AnOldMan

do you have an admin icon on your desktop?
if not type in the ip addx 192.168.1.1 and see if you go to the admin.
on network connections , right click on my network places, click map network drive,
select a drive letter and then browse for the two folders on the "myserver" select one of them and click apply or ok. the drive will show up in mycopmuter do the same for the other folders
as far as the log in is concerned it is best to set a level 3 user name and pw on the server then do the same user name and pw for a new windows login user.