Ice Maker is dripping water - Electrolux EI28BS56IS (278 cu ft) Bottom Freezer Commercial French Door Refrigerator

If it overfills and drips, look for an adjustment behind the plastic endcover with a +/- on it. - is less water.

If it continuously drips, replace the water inlet valve on the back where the house water supply comes in.

water dispenser -Your water inlet valve on the back where the water supply comes in is probably leaking. disconnect the water line coming out of it and see if you have a slow drip. Try the dispenser to see if it's just drips after use.


ice maker - If it overfills and drips, look for an adjustment behind the plastic endcover with a +/- on it. - is less water.

If it continuously drips, replace the water inlet valve on the back where the house water supply comes in.

If it overfills and drips, look for an adjustment behind the plastic endcover with a +/- on it. - is less water.

If it continuously drips, replace the water inlet valve on the back where the house water supply comes in.
The water inlet valve on the back of unit opens when the ice maker needs water. If the valve doesn't seal good because of sediment or wear it will continue to drip and when the water reaches the ice maker supply tube it will freeze. You can take the water line off the valve and watch to see if it drips.

Probably the solenoid valve leaks(electric valve that opens when the ice maker calls for water) and overflood the ice maker,the only way to fix this is replacing the solenoid.

The water inlet valve on the back of unit opens when the ice maker needs water. If the valve doesn't seal good because of sediment or wear it will continue to drip and when the water reaches the ice maker supply tube it can freeze and block the tube or keep dripping into the ice mold. . You can take the water line off the valve and watch to see if it drips.

If it overfills and drips, look for an adjustment behind the plastic endcover with a +/- on it. - is less water.

If it continuously drips, replace the water inlet valve on the back where the house water supply comes in.
The water inlet valve on the back of unit opens when the ice maker needs water. If the valve doesn't seal good because of sediment or wear it will continue to drip and when the water reaches the ice maker supply tube it will freeze diverting the water. You can take the water line off the valve and watch to see if it drips.

The dual water valve (solenoid) that open and let the water from the line when the ice maker calls for it, is leaking and needs to be replaced.

If it overfills and drips, look for an adjustment behind the plastic endcover with a +/- on it. - is less water.

If it continuously drips, replace the water inlet valve on the back where the house water supply comes in.

Watch it when it fills with water. The fill tube could also be stopped up with ice. The water inlet valve on the back of unit opens when the ice maker needs water. If the valve doesn't seal good because of sediment or wear it will continue to drip and when the water reaches the ice maker supply tube it will freeze. You can take the water line off the valve and watch to see if it drips.

If your i/m is dripping you most likely have a crack in the ice mold, you should replace the ice maker.

In most of theses cases the dripping is caused by the molding in the ice maker cracking and the water is wicked out. On some ice makers you can replace the complete molding but its usually easier to just replace the ice maker.