I tried to take a picture at night of the christmas tree with lights on on the tree - all other house lights were out and the picture still turns out bright like I had lights on-is there a special setting I should use

Question edited for clarity.

The link says it has a reset

https://www.google.com/search?q=gemmy+holiday+light+show+4+feet+christmas+tree+not+working+properly

..

Setting Up your Pre-Lit Christmas Tree - YouTube

? 4:56
https://www.youtube.com/watch?v=qe1fbGZV-Ys
Jul 3, 2008 - Uploaded by Christmas Central
Here are instructions on how to put up your pre-lit Christmas Tree, courtesy of http://www.christmascentral ...

Video: How To Assemble a Pre Lit Artificial Tree by Sterling ...

www.christmascentral.com/t-Video-How-To-Assemble-a-Pre-Lit-Artifici...

Learn how to assemble your Artificial Christmas Tree in less than 10 minutes! Sterling Inc has teamed up with Christmas Central to make this instructional video; ... Do you want to learn how to decorate like the pros? ... These lights can be used for all kinds of visual motion effects, from a waterfall to a flashing starfield!Missing: everstar

We purchased an Everstar pre-lit Christmas Tree - Fixya

No, it is a myth. The White House said

"There is no truth to this, and the letter referenced ............ does not exist. No letter has gone out yet from the White House pertaining to Christmas tree ornaments. The trees in the White House will be called Christmas trees, and the tree on the Ellipse will be called the National Christmas Tree. There will be no name changes.

http://www.allposters.com/-sp/Lighted-Christmas-Tree-in-Wheelbarrow-Posters_i8665503_.htm

the candles will not have had anything to do with the fuse blowing on your tree the fault is soley with the tree fuses are available at any good electronics parts store just make sure you only use 120v 6amp if the fuse blows again you have a serious fault with the tree and dont use the lights.

in some cases fuses blow on there own fault so if the fuse last then it was simply a worn fuse

best of luck

merry christmas

please take the time to rank this advice

Did you plug one section of the tree back into itself?

Here's what you do... This is for the trio christmas tree light show.
What you need.... small precision pointing tool.
On the largest tree base electrical box there is a push button. Press and release that button. A red led will flash indicating the box is in sync mode. turn the remote on and on the back of your remort, there is a small hole with the words reset over the top of it. Using the small precision pointing tool, press the recessed button and release. The remote will sync to the base unit. Walla!! Merry Christmas to all!!!

No flash and set the shutter a little slow also use a camera stand if possible!

try using a different setting on the camera for these pictures, use the scene selection and choose night scene.