I am trying to set the correct time on the Casio Oceanus 4364 but can't get it to timesetting mode correctly.

Note how the buttons around the outside edge of the watch match up to the compass directions on the outer ring of the watch face. Use the butttons on the NW, NE, SE, and SW positions.

1. To enter time setting mode, press and hold NW until the Seconds start to flash. (You can exit time setting mode at any point by pressing NW twice)
2. Release NW and press SE to reset the Seconds to 00.
3. Press SW and the Hours will start to flash.
4. Set the hour by pressing NE (down) or SE (up) Press the lower button to move up and the upper button to move down.
5. When the hour is correct, press SW and the Minutes will flash.
6. Set the minutes by pressing NE (down) or SE (up)
7. When the minurtes are correct, press SW and the 12/24hr setting will flash.
8. Switch between 12hr mode and 24 hour mode by pressing SE.
9. Press SW and the Year will flash.
10. Set the year by pressing NE (down) or SE (up)
11. When the year is correct, press SW and the Month will flash.
12. Set the month by pressing NE (down) or SE (up)
13. When the month is correct, press SW and the Day will flash.
14. Set the day by pressing NE (down) or SE )
15. When the day is correct, press SW and the seconds will flash again.
16. Exit time setting mode by pressing NW twice.

This is a complex watch. You can download a manual here http://www.casio.com/products/archive/Watches/PRO_TREK/SPF40-1V/

Check out my (escapement) TIPS AND TRICKS. Browse through them and you will find link to all Casio watch manuals. Get yours and read carefully.

Hi jmalone1961,

I see that you need assistance on getting to set the time on your Casio 4364 watch.

I have put a link to where you can acquire the User Manual for this watch, I would like to type in the details but there will be so much that it may get more confusing if I translate the manual.

Pleasee the link below.

http://www.oceanus-us.com/support/downloads/manuals/module_4364.pdf

Thanks,

mvincentc

For all those who lost their Casio watch manual. Follow this link, fill in the requested details and download manual. http://world.casio.com/wat/download/en/manual/

I am not American, so I am not familiar with the definition of "EST" or which of the four "city" settings is correct for you.

Having read the instructions I see that for America you have to select "USA" first and then the appropriate city, have you done this?. The list of four options covers 4 time zones, so you should be able to get the correct time for your area.

When I bought an atomic watch recently, I had to leave it overnight to catch the timekeeping signals. I see that you posted your question only 14 hours ago. How long have you had it. GIve your watch a day or so for it to latch on to the correct time.

Check that the "autoreceive" is "on".

Check that the daylight saving time (DST) is correctly set. The manuals indicate that some areas may not be using it?

Keep trying - it is nice to have a watch that is always correct!

Hi david91408,

You have to start this timesetting procedure by pressing button "A" upper left, while in standard timekeeping mode. The "seconds" will start flashing.
Then press "C" lower left to cycle through the various modes. Each further press will cycle as follows: Seconds >> Hours >> Minutes >> Year >> Month >> Date...then back to Seconds.
While in each mode, press "E" lower right monentarily and continuously to change to the correct time and date. Remember to press "C" after each change.

Be aware of "PM" indicator to make sure you get the watch timing correct in order to roll over the date at midnight.
When done press "A" again to go back to standard mode.

It appears your watch module is #1289. You can also download a PDF manual here for more complete operation of all facets of your watch:
http://ftp.casio.co.jp/pub/world_manual/wat/en/qw1289.pdf

Let me know if I can help further.

Regards, Bill

You can get instructions from the Casio web site.

Go to the casio web site "casio.com".

Select "support" and the "manuals", watches;

Accept terms

Select "watch manual archive"

Read the number of the back of your watch and enter it into the search box

Click on "search" and the download your instructions.

You can get manual information from the Oceanus web site (NOT casio strangely enough!).

Insert "www.oceanus-us.com/" into your search engine

Select "support", then "Manual information"

Enter your model number and download the information. There are instructions on choice of home city and further adjustments if it still is not correct after initial setting up.

1. Look in the back of your watch, it will show the model number (in a square on top of "CASIO")
2. Look at this web page for the right manual:http://www.oceanus-us.com/index.php?fuseaction=support.content&CNT_ID=14884814-F2AB-46E6-93DC-5E678BD11926
3. Look at the section "Adjusting the Home Positions" - that is where the answer is.

For setting Time & Date...
1. Push "MODE" button three times (change Mode to TimeSet)
Time -> StopWatch -> AlarmTimeSet -> TimeSet -> Time ->...
2. Flashing Second Number Digits
3. Push "RESET" to select...
Second -> Minute -> Hour(12hr<->24hr) ->...
Date -> Month -> Day of Week -> Second -> ....(repeat)
4. Use "START" to set each item...

For setting Alarm ON/OFF
1. Push "RESET" button then Push "START" same time...
Alarm ON -> Alarm OFF -> ... (repeat)